This chapter describes the Cisco NX-OS Routing Information Protocol (RIP) commands that begin with F.
To enable the Routing Information Protocol (RIP), use the featurerip command. To disable RIP, use the no form of this command.
no feature rip
This command has no arguments or keywords.
Global configuration mode
This command was introduced.
You must enable the RIP feature before you can configure RIP.
Note In Cisco NX-OS Release 5.0(3)N1(1), a software upgrade on the Cisco Nexus 5548 switch and the Cisco Nexus 5596 switch that has the Layer 3 features enabled is disruptive. You must reload the switch and the Cisco Nexus 2000 Series Fabric Extender.
This command does not require a license.
Note Make sure the LAN Base Services license is installed on the switch to enable Layer 3 interfaces.
This example shows how to enable the RIP feature:
switch# configure terminal
switch(config)# feature rip
This example shows how to disable the RIP feature: