This chapter describes the Cisco NX-OS Hot Standby Router Protocol (HSRP) commands that begin with F.
To enter Hot Standby Router Protocol (HSRP) configuration mode and enable HSRP, use the feature hsrp command. To disable HSRP, use the no form of this command.
no feature hsrp
The command has no arguments or keywords.
Global configuration mode
This command was introduced.
You must enable the HSRP feature before you can configure HSRP.
Note In Cisco NX-OS Release 5.0(3)N1(1), a software upgrade on the Cisco Nexus 5548 switch and the Cisco Nexus 5596 switch that has the Layer 3 features enabled is disruptive. You must reload the switch and the Cisco Nexus 2000 Series Fabric Extender.
This command does not require a license.
This example shows how to enable HSRP on the switch: