This chapter describes the Cisco NX-OS Hot Standby Router Protocol (HSRP) commands that begin with D.
To delay the Hot Standby Router Protocol (HSRP) initialization after a reload or after an interface comes up, use the delay minimum command. To disable this function, use the no form of this command.
delay minimum [min-delay]reload[reload-delay]
no delay minimum [min-delay]reload[reload-delay]
(Optional) Minimum time (in seconds) to delay HSRP group initialization after an interface comes up. This period applies to all subsequent interface events. The default is 0 seconds.
Specifies the time period to delay HSRP group initialization after the router has reloaded. This period applies only to the first interface-up event after the router has reloaded. The default is 0 seconds.
The HSRP delay default is 0 seconds.
Interface configuration mode
This command was introduced.
Use the delay hsrp command to delay HSRP initialization either after a reload or after an interface comes up. This configuration allows the interface and router to stabilize after the interface comes up and helps to prevent HSRP state flapping.
This example shows how to configure a minimum delay of 3 seconds and a group initialization delay of 10 seconds:
switch(config)# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# ip address 172.16.6.5 255.255.255.0