Cisco Discovery Protocol (CDP) runs over the data link layer and is used to advertise information to all attached Cisco devices, and to discover and view information about attached Cisco devices. CDP runs on all Cisco-manufactured equipment.
You must create a domain ID for Cisco Nexus 1000V. This process is part of the initial setup of the Cisco Nexus 1000V when installing the software. If you need to create a domain ID later, use the saves-domain command to configure.
You can establish Layer 3 Control in your VSM domain so that your VSM is Layer 3 accessible and able to control hosts that reside in a separate Layer 2 network.
In order to connect to vCenter Server or an ESX server, you must first define the connection in the Cisco Nexus 1000V. Managing Server Connections describes how to connect and disconnect with vCenter Server and viewing connections.
The Cisco Nexus 1000V provides you with the capability to change the switch name, configure messages of the day, and display, save, and erase configuration files.
Using a single interface, you can manage the file system including:
Flash memory file systems
Network file systems (TFTP and FTP)
Any other endpoint for reading or writing data (such as the running configuration).
You can identify the users currently connected to the device and send a message to either a single user or all users.
The Network Time Protocol (NTP) synchronizes timekeeping among a set of distributed time servers and clients. This synchronization allows you to correlate events when you receive system logs and other time-specific events from multiple network devices.
Local SPAN and ERSPAN
The Ethernet switched port analyzer (SPAN) lets you monitor traffic in and out of your device, and duplicate packets from source ports to destination ports. For information about configuring SPAN, see Configuring Local SPAN and ERSPAN section. You can also use the Cisco Network Analysis Module (NAM) to monitor ERSPAN data sources for application performance, traffic analysis, and packet header analysis. To use NAM for monitoring the Cisco Nexus 1000V ERSPAN data sources, see the Cisco Nexus 1010 Network Analysis Module Installation and Configuration Note.
The Simple Network Management Protocol (SNMP) is an application-layer protocol that provides a message format for communication between SNMP managers and agents. SNMP provides a standardized framework and a common language used for the monitoring and management of devices in a network.
NetFlow gives visibility into traffic transiting the virtual switch by characterizing IP traffic based on its source, destination, timing, and application information. This information is used to assess network availability and performance, assist in meeting regulatory requirements (compliance), and help with troubleshooting.
You can also use the Cisco Network Analysis Module (NAM) to monitor NetFlow data sources.
You can use system message logging to control the destination and to filter the severity level of messages that system processes generate. You can configure logging to a terminal session, a log file, and syslog servers on remote systems. System message logging is based on RFC 3164.
For more information about the system message format and the messages that the device generates, see the Cisco Nexus 1000V Series
NX-OS System Messages Reference.
The iSCSI multipath feature sets up multiple routes between a server and its storage devices for maintaining a constant connection and balancing the traffic load.
Ping and trace route are among the available troubleshooting tools. For more information, see the Cisco Nexus 1000V