Table Of Contents

Q Commands

qos control priority

Q Commands

---

The commands in this chapter apply to the Cisco MDS 9000 Family of multilayer directors and fabric switches. All commands are shown here in alphabetical order regardless of command mode. Please see the Command Mode section to determine the appropriate mode for each command. For more information, see the Cisco MDS 9000 Family Configuration Guide.

•qos control priority

qos control priority

To disable support for the QOS priority assignment for control traffic feature on the MDS 9000 family of switches, use the qos control command.

qos control priority value

no qos control value

Syntax Descriptionfcdomainfcdomainfcdomainfcdomain

qos control	Controls QOS traffic from one fabric controller to another
priority	Sets priority: 0=lowest, 7=highest (default).
value	Priority values range from 0=lowest, 7=highest (default).
no	Disables the control traffic QoS feature.

Defaults

Enabled, priority value=7 (highest).

Command Modes

Configuration mode

Usage Guidelines

None.

Examples

switch# config t

switch(config)# no qos control priority

0  0=lowest, 7=highest (default, use no as prefix)

switch(config)# qos control priority 0

  0  0=lowest, 7=highest (default, use no as prefix)

switch(config)# 

Related Commands

Command	Description
show qos internal	Shows internal debug information
show qos statistics	Shows QoS related statistics