Table Of Contents
SN 5420 Storage Router Specifications
Regulatory Standards Compliance
EMC Environmental Conditions for Product to be Installed in the European Union
SN 5420 Storage Router Specifications
This appendix provides chassis specifications and regulatory compliance standards information for the SN 5420 storage router. The appendix includes the following sections:
•
Regulatory Standards Compliance
Chassis Specifications
Table A-1 describes the chassis specifications for the SN 5420 storage router.
Table A-1 SN 5420 Storage Router Chassis Specifications
Temperature, ambient operating
32 to 104°F (0 to 40°C)
Temperature, ambient nonoperating and storage
-40 to 185°F (-40 to 85°C)
Humidity (RH), ambient (non-condensing) operating
10 to 95 percent non-condensing
Humidity (RH), ambient (noncondensing) nonoperating and storage
10 to 95 percent non-condensing
Altitude, operating and nonoperating
-500 to 10,000 ft (-152.4 to 3,048 m)
Dimensions (H x W x D)
1.75 x 17 x 15.5 in. (4.4 x 43.2 x 39.4 cm)
1 RUs1 in heightWeight
7.5 lb (3.4 kg)
Power supply output
70W
System power dissipation
35W
AC current
1.0A maximum @ 100 to 120 VAC
0.5A maximum @ 200 to 240 VACAC frequency
50 to 60 Hz
Airflow
Right and left side in, rear out
Fuse (F1) rating
1A, 250 VAC, time delay
1 RU = rack unit
Regulatory Standards Compliance
The SN 5420 storage router complies with the standards listed in Table A-2. See the following sections for EMC notices and warnings:
•
•
Table A-2 SN 5420 Storage Router Regulatory Standards Compliance
Regulatory Compliance
Products bear CE Marking indicating compliance with the (89/366/EEC, 73/23/EEC) directives, which includes the following safety and EMC standards.
Safety
UL 609501
CAN/CSA-C22.2 No. 9502
EN 609503
IEC 609504
TS 0015
AS/NZS 32606
EMC7
FCC (CFR 47, part 15) Class A8 , 9
EN 55022 Class A with UTP10 cabling
EN 55022 Class B with FTP11 cabling
CISPR 2212 Class A with UTP cabling
CISPR 22 Class B with FTP cabling
AS/NZS 354813 Class A with UTP cabling
AS/NZS 3548 Class B with FTP cabling
VCCI14 Class A with UTP cabling
VCCI Class B with FTP cabling
EN 55024
EN 50082-1
ICES 003 Class A
ETS 300 386-215
1 UL = Underwriters Laboratories
2 CSA = Canadian Standards Association
3 EN = European Norm
4 IEC = International Electrotechnical Commission
5 Technical Standard (Australian Communications Authority)
6 AS/NZS = Australia/New Zealand Standards
7 EMC = electromagnetic interference compatibility
8 FCC = Federal Communications Commission
9 CFR = Code of Federal Regulations
10 UTP = unshielded twisted-pair
11 FTP = foil-screened twisted pair
12 CISPR = Comite Internations Special Des Perturbations Radioelectrigues
13 AS/NZS = Australia/New Zealand Standards
14 VCCI = Voluntary Control Council for Information Technology Equipment - Japan Standard
15 ETS = European Telecommunications Standards
EMC Environmental Conditions for Product to be Installed in the European Union
This equipment is intended to operate under the following environmental conditions with respect to EMC:
1.
2.
3.
In addition, if equipment is operated in a domestic environment, interference may occur.
(FCC) Class A Warning
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
Canada Class A Warning
This Class 'A' digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la classe 'A' est conforme á la norme NMB-003 de Canada.
(CISPR 22) Class A Warning
This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
Japan (VCCI) Class A Warning
Translation
This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.
Taiwan (BSMI) Class A Warning
Translation
This is a Class A Information Product, when used in residential environment, it may cause radio frequency interference, under such circumstances, the user may be requested to take appropriate countermeasures.
Hungarian Class A Warning
Figyelmeztetés a felhasználói kézikönyv számára: Ez a berendezés "A" osztályú termék, felhasználására és üzembe helyezésére a magyar EMC "A" osztályú követelményeknek (MSZ EN 55022) megfeleloen kerülhet sor, illetve ezen "A" osztályú berendezések csak megfelelo kereskedelmi forrásból származhatnak, amelyek biztosítják a megfelelo speciális üzembe helyezési körülményeket és biztonságos üzemelési távolságok alkalmazását.
Translation
This equipment is a class A product and should be used and installed properly according to the Hungarian EMC Class A requirements (MSZEN55022), the Class A equipment are derived for typical commercial establishments for which special conditions of installation and protection distance are used.
