Table Of Contents

SNMP Traps

Major Alarm Traps

Port Error Traps

Reset Traps

System Events Traps

Layer 1 Alarm Traps

SNMP Traps

---

The Cisco VG30D Voice Gateway is configured to generate SNMP Traps for up to 8 destinations. SNMP traps have been divided into five groups as follows:

•Major Alarm

•Port Errors

•Reset Traps

•System Events

•Layer 1 Alarms

To access the MIBs which define the Cisco VG30D Voice Gateway Traps may be accessed through links provided on the SNMP Configuration page when using the Cisco VG30D Voice Gateway Management Interface. Using the Save As facility in the browser, these MIBs may be saved to allow the information to be compiled into the Network Management System (NMS).

Major Alarm Traps

Trap Code	Description
45	Port is not operational
46	Port has been commissioned
47	Port has been decommissioned

Port Error Traps

Trap Code	Description
1	Layer 1 is operational
2	Layer 1 is not operational
20	Layer 2 is misconfigured
21	Layer 2 is operational
22	Layer 2 is not operational
30	Layer 3 is operational
31	Layer 3 is not operational
32	Layer 3 disabled
35	Alarm propagation on
36	Alarm propagation off
40	Loopback mode detected
41	Loopback mode cleared
42	Port impedance is set to 75 ohm
43	Port impedance is set to 120 ohm

Reset Traps

Trap Code	Description
55	Unit has been reset
90	Unit reset after restoring configuration

System Events Traps

Trap Code	Description
50	Fatal or watchdog error
51	Major alarms have been acknowledged
62	Media card fatal
70	Factory/Post is set to POST
71	Factory/Post is set to FACTORY
72	Management IP address change from craft port
73	Management subnet mask change from craft port
74	Management IP address change from webserver
75	Management subnet mask change from webserver
76	New software has been installed
77	New software has been activated by the webserver
78	New software has been activated by the Craft port
79	Webserver login detected
80	Webserver logout detected
81	Webserver login fail
82	System fully operational
83	Default configurations have been applied
91	Failed to restore configuration

Layer 1 Alarm Traps

Trap Code	Description
3	Layer 1 enabled
4	Layer 1 disabled
5	Layer 1 no signal
6	Layer 1 receiving AIS
7	Layer 1 lost sync
8	Layer 1 transmitting AIS
9	Layer 1 receiving RAI
10	Layer 1 has excessive errors
11	Layer 1 receiving RAI and E bits
12	Layer 1 transmitting no signal