Table Of Contents
H.323 Support for Virtual Interfaces
This feature was introduced.
Support was added for the Cisco AS5350 and Cisco AS5400 universal gateways.
This document describes the H.323 Support for Virtual Interfaces that was introduced in Cisco IOS Release 12.1(2)T. This document contains the following sections:
The H.323 Support for Virtual Interfaces feature allows users to configure the IP address of the gateway, so that the IP address include in the H.323 packet is deterministic and consistently indicates the same address for the source.
In previous releases of the Cisco IOS software, the source address included in the H.323 packet could vary depending on the protocol (RAS, H.225, H.245, or RTP). This makes it difficult to configure firewall applications to work with H.323 messages.
The H.323 Support for Virtual Interfaces feature addresses that difficulty by allowing the user to explicitly configure an IP address to be used for all protocols.
The H.323 Support for Virtual Interfaces feature has no restrictions or limitations.
Configuring H.323 VoIP Gateway for Cisco Access Platforms
The H.323 Support for Virtual Interfaces feature is supported on any existing IOS voice platforms, including the following:
•Cisco 2500 series
•Cisco 2600 series
•Cisco 3600 series
•Cisco 7200 series
Supported Standards, MIBs, and RFCs
No new or modified standards are supported by this feature.
No new or modified MIBs are supported by this feature.
To obtain lists of MIBs supported by platform and Cisco IOS release and to download MIB modules, go to the Cisco MIB web site on Cisco Connection Online (CCO) at http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.
No new or modified RFCs are supported by this feature.
The Cisco AS5350 and Cisco AS5400 do not support the Mica Modem Card, Microcom Modem Card, or VoIP Feature Card. Voice and modem functions are provided by the Universal Port Dial Feature card running SPE firmware. See the Cisco AS5350 Universal Gateway Card Installation Guide and the Cisco AS5400 Universal Gateway Card Installation Guide for more information. All references to the Cisco AS5300 in this document apply to the Cisco AS5350 and Cisco AS5400 platforms with the following exceptions:
•Use the Universal Port Dial Feature Card instead of the Mica or Microcom modem cards.
•Use SPE firmware instead of portware version 6.7.7.
•Run Cisco IOS Release 12.1(5)XM2 software for VoIP functionality.
The H.323 Support for Virtual Interfaces feature requires the Cisco H.323 VoIP Gateway for Cisco Access Platforms feature.
See the following sections for configuration tasks for the H.323 Support for Virtual Interfaces feature. Each task in the list indicates if the task is optional or required.
•Verifying the Gateway's Source IP Address (optional)
Configuring the H.323 Support for Virtual Interfaces
To use the H.323 Support for Virtual Interfaces feature, first ensure that the VoIP gateway functionality is enabled. For more information about enabling the VoIP gateway functionality, see Configuring H.323 VoIP Gateway for Cisco Access Platforms. To configure a source IP address for the gateway, do the following:
Verifying the Gateway's Source IP Address
To verify the gateway's source IP address, enter the show run command. The output shows the source IP address that is bound to the interface.router# show runBuilding configuration...Current configuration:!...interface Loopback0ip address 188.8.131.52 255.255.255.0no ip directed-broadcasth323-gateway voip bind srcaddr 184.108.40.206!interface Ethernet0/0ip address 172.18.194.50 255.255.255.0no ip directed-broadcasth323-gateway voip interfaceh323-gateway voip id j70f_2600_gk2 ipaddr 172.18.194.53 1719h323-gateway voip h323-id j70f_3640_gw1h323-gateway voip tech-prefix 3#...
In the following example, the Ethernet 0/0 interface is used as the gateway interface. For convenience, we have also specified the h323-gateway voip bind srcaddr command on the same interface. The designated source IP address is the same as the IP address assigned to the interface.interface Ethernet0/0ip address 172.18.194.50 255.255.255.0no ip directed-broadcasth323-gateway voip interfaceh323-gateway voip id j70f_2600_gk2 ipaddr 172.18.194.53 1719h323-gateway voip h323-id j70f_3640_gw1h323-gateway voip tech-prefix 3#h323-gateway voip bind srcaddr 172.18.194.50
This section documents new or modified commands. All other commands used with this feature are documented in the Cisco IOS Release 12.1 command reference publications.
h323-gateway voip srcaddr
To designate a source IP address for the voice gateway, use the h323-gateway voip bind srcaddr command. To remove the source IP address, use the no form of the command.
h323-gateway voip bind srcaddr ipaddr
no h323-gateway voip bind srcaddr
There are no default behaviors or values for this command.
This command was introduced.
The command was introduced for the Cisco AS5350 and CiscoAS5400.
You do not have to issue it on the interface that you defined as the voice gateway interface (although it may be more convenient to do so). Use this command the interface that contains the IP address to which you want to bind.
The following example assigns a source IP address of 220.127.116.11:h323-gateway voip bind srcaddr 18.104.22.168
gatekeeper—A gatekeeper maintains a registry of devices in the multimedia network. The devices register with the gatekeeper at startup, and request admission to a call from the gatekeeper.
The gatekeeper is an H.323 entity on the LAN that provides address translation and control access to the LAN for H.323 terminals and gateways. The gatekeeper may provide other services to the H.323 terminals and gateways, such as bandwidth management and locating gateways.
gateway—A gateway allows H.323 terminals to communicate with non-H.323 terminals by converting protocols. A gateway is the point at which a circuit-switched call is encoded and repackaged into IP packets.
A H.323 gateway is an endpoint on the LAN that provides real-time, two-way communications between H.323 terminals on the LAN and other ITU-T terminals in the WAN, or to another H.323 gateway.
H.323—An International Telecommunication Union (ITU-T) standard that describes packet-based video, audio, and data conferencing. H.323 is an umbrella standard that describes the architecture of the conferencing system, and refers to a set of other standards (H.245, H.225.0, and Q.931) to describe its actual protocol.
RAS—Registration, admission, and status protocol. This is the protocol that is used between endpoints and the gatekeeper to perform management functions. The RAS signaling function performs registration, admissions, bandwidth changes, status, and disengage procedures between the VoIP gateway and the gatekeeper.
RTP—Real-time transport protocol. One of the IPv6 protocols. RTP is designed to provide end-to-end network transport functions for applications transmitting real-time data, such as audio, video, or simulation data, over multicast or unicast network services. RTP provides services such as payload type identification, sequence numbering, timestamping, and delivery monitoring to real-time applications.
VoIP—Voice over IP. The ability to carry normal telephone-style voice over an IP-based Internet with POTS-like functionality, reliability, and voice quality. VoIP is a blanket term which generally refers to Cisco's standards-based (H.323, etc.) approach to IP voice traffic.
Note For a list of other internetworking terms, see Internetworking Terms and Acronyms, available on the Documentation CD-ROM and Cisco Connection Online (CCO) at the following URL: http://www.cisco.com/univercd/cc/td/doc/cisintwk/ita/index.htm.