Table Of Contents

CDR Command

dial-control-mib

Syntax Description

Default

Command Mode

Usage Guidelines

Example

Related Commands

CDR Command

---

This chapter describes the following command used to configure the Call Detail Records (CDR) feature on the Cisco MC3810:

•dial-control-mib

dial-control-mib

To specify attributes for the call history table, use the dial-control-mib global configuration command.

dial-control-mib {max-size number | retain-timer number}

Syntax Description

max-size number	Specifies the maximum size of the call history table. Valid entries are from 0 to 500 table entries. A value of 0 prevents any history from being retained.
retain-timer number	Specifies the length of time, in minutes, for entries in the call history table. Valid entries are from 0 to 2147483647 minutes. A value of 0 prevents any history from being retained.

Default

The default call history table length is 50 table entries. The default retain timer is 15 minutes.

Command Mode

Global configuration

Usage Guidelines

This command first appeared in Cisco IOS Release 11.3(1)T.

This command first applied to the CDR feature on the Cisco MC3810 in Cisco IOS Release 12.0(2)T.

Example

The following example configures the call history table to hold 400 entries, with each entry remaining in the table for 10 minutes:

configure terminal

 dial-control-mib max-size 400

 dial-control-mib retain-timer 10

Related Commands

show call history voice record