Table Of Contents

Technical Specifications

Technical Specifications

---

Table A-1 lists the specifications for the Cisco 10008 router.

Table A-1 Cisco 10008 Router System Specifications 

Description	Specifications
Physical specifications	•Weight: 130 lb (59.02 kg) fully configured chassis •Height: 21.75 in. (55.2 cm) •Width: 17.5 in. (44.4 cm) •Depth: 12.0 in. (30.4 cm) •Chassis depth with front cover: 13.75 in. (34.9 cm) •Mounting: 19 in. or 23 in. rack mountable (front or mid), 3 units per 7 ft rack
Temperature range	•Operating: 41 degrees F to 104 degrees F (5 degrees C to 40 degrees C) Short-term operating temperature is limited to 131 degrees F (55 degrees C) in compliance with Bellcore GR-63 •Storage: -40 degrees F to 158 degrees F (-40 degrees C to 70 degrees C)
Relative humidity	•Operating—nominal: 5 percent to 85 percent •Operating—short term: 5 percent to 90 percent •Storage: 5 percent to 95 percent
Operating altitude	-197 ft to 13,123 ft (-60 m to 4000 m)
Airflow	150 cfm1 through the system blower module 200 cfm through the system blower module if the exhaust temperature exceeds 45 degrees C
Power entry modules	DC PEM Supports up to two separate -48 VDC input feeds by means of built-in two-position terminal blocks •Part Number: ESR-PWR-DC (Primary) Part Number: ESR-PWR-DC\R (Redundant) •DC input voltage: -48 to -60 VDC •DC input current: 20A @ -48 VDC •Power consumption: 1200W maximum •Heat dissipation: 3768 Btu2 /hr AC PEM •Part Number: ESR-PWR-AC (Primary) Part Number: ESR-PWR-AC\R (Redundant) •AC inlet power connector: IEC 320 C20 •AC input voltage: 100 to 240 VAC, 50/60 Hz, single phase •AC input current: 15 to 7 A •Power consumption: 1400W maximum •Heat dissipation: 4760 Btu/hr
Performance routing engine (PRE)	•Part Number: ESR-PRE1 (Primary) Part Number: ESR-PRE1/R (Redundant) •Power: 80W •Max per chassis: 2 •Weight: 7.5 lb (3.41 kg) Height: 16.0 in. (40.64 cm) Depth: 9.97 in. (25.32 cm) Width: 1.91 in. (4.84 cm) Three Interface ports: •RJ-45 IEEE 802.3 Ethernet 100BASE-T •RJ-45 auxiliary (AUX) port for modem access •RJ-45 console (CON) port for terminal access Two PCMCIA Flash card slots: •Slot 0 •Slot 1
PRE PCMCIA Flash disk card options	•40 MB—Part Number: ESR-PRE-MEM-FD40 •128 MB—Part Number: ESR-PRE-MEM-FD128
PRE DRAM memory options	•256 MB—Part Number: ESR-PRE-MEM-256M •512 MB—Part Number: ESR-PRE-MEM-512M

1 cfm = cubic feet per minute 2 Btu = British thermal units

For Specifications for Operating and Nonoperating Environments, see "Site Environmental Requirements" section on page 2-2.

For technical specifications for the Cisco 10008 line cards, see the Cisco 10000 Line Card Hardware Installation Guide.

For regulatory compliance and safety information, see the Regulatory Compliance and Safety Information for the Cisco 10000 Series Routers document.