Table Of Contents

APPLY Commands

2.1  APPLY

APPLY Commands

---

This chapter provides apply (APPLY) commands for the Cisco ONS 15454 SDH, Cisco ONS 15454 M2, and Cisco ONS 15454 M6.

---

Note All commands supported on the Cisco ONS 15454 SDH platform are also supported on Cisco ONS 15454 M2 and Cisco ONS 15454 M6 platforms.

---

2.1  APPLY

(Cisco ONS 15454 SDH) The Apply (APPLY) command activates or reverts a software load during a software upgrade or downgrade process.

Usage Guidelines

An error will be generated if you attempt to activate an older software load or attempt to revert to a newer software load.

Category

File Transfer

Security

Superuser

Input Format

APPLY:[<TID>]::<CTAG>[::<MEM_SW_TYPE>];

Input Example

APPLY:CISCO::123::ACT;

Table 2-1 APPLY Commands - Parameter Support

Input Parameters	Description	ONS 15454 SDH
<MEM_SW_TYPE>	(Optional) Memory switch action during the software upgrade. The parameter type is DL_TYPE, which indicates the software download type. The default value is ACT.	Y
•ACPT	Activates to a newer software load on the active controller card and resets the active card.	N
•CANC	Cancels the software download.	N
•RVRT	Reverts to an older software load during software download.	Y
•ACT	Activates to a new software load.	Y