Cisco MPLS Diagnostics Expert 2.1.3 Failure Scenarios Guide on ISC 5.1
Chapter 3: Commands
Download this chapter
Chapter 3: CommandsChapter 3: Commands
Download the complete book
Cisco MPLS Diagnostics Expert 2.1.3 Failure Scenarios Guide on ISC 5.1 (Entire Book Length PDF)Cisco MPLS Diagnostics Expert 2.1.3 Failure Scenarios Guide on ISC 5.1 (Entire Book Length PDF) (PDF - 890 KB)
give_us_feedback

Table Of Contents

Commands

3.1  Introduction

3.2  IOS Commands

3.3  IOS XR Commands


Commands

This chapter provides the following information:

•Introduction

•IOS Commands

•IOS XR Commands

3.1  Introduction

This chapter provides details of all IOS and IOS XR commands executed by the troubleshooting workflows in the Cisco MPLS Diagnostics Expert (MDE) 2.1.3 application for the Cisco IP Solution Center (ISC) Release 5.1.

3.2  IOS Commands

This section lists the IOS commands used by MDE. If TACACS+ (or another authentication/authorization system) is used, ensure that these are all allowed for MDE.

Note This list might be updated when MDE releases or patches are made available, e-mail: mpls-diagnostics-expert@cisco.com for the latest list.

1. attach <slot> show version

2. execute-on slot <slot> 'show mpls forwarding-table <destinationPrefix> <subnetMask>'

3. execute-on slot <slot> 'show mpls forwarding-table <destinationPrefix>'

4. execute-on slot <slot> 'show mpls forwarding-table vrf <vrfName> <destinationPrefix> <subnetMask>'

5. execute-on slot <slot> 'show mpls forwarding-table vrf <vrfName> <destinationPrefix>'

6. execute-on slot <slot> 'show mpls forwarding-table vrf <vrfName>'

7. execute-on slot <slot> 'show mpls forwarding-table'

8. execute-on slot <slot> show ip cef vrf <vrfName> <networkPrefix>

9. execute-on slot <slot> show ip cef vrf <vrfName> <networkPrefix> <subnetMask>

10. execute-on slot <slot> show version

11. ping (interactive)

12. ping <targetIp>

13. ping mpls ipv4 <targetIp>/<targetIpSubnetMask> source <source> sweep <minSweepSize> <maxSweepSize> <sweepInterval> <repeatCount> timeout <timeout> replyMode <replyMode>

14. ping mpls traffic-eng Tunnel <tunnelNumber>

15. ping vrf <vrfName> (interactive)

16. show access-lists <listName>

17. show atm map

18. show atm pvc <interface>

19. show cef drop

20. show cef drop | include ^<slot>

21. show frame-relay lmi

22. show frame-relay lmi interface <interface>

23. show frame-relay map

24. show frame-relay pvc <interface> dlci <dlci>

25. show interfaces <interface>

26. show ip bgp summary

27. show ip bgp vpnv4 <vrfName> rib-failure

28. show ip bgp vpnv4 all neighbors

29. show ip bgp vpnv4 all neighbors <destIp>

30. show ip bgp vpnv4 all | include local router

31. show ip bgp vpnv4 vrf <vrfName> <networkPrefix>

32. show ip bgp vpnv4 vrf <vrfName> neighbors <destIp>

33. show ip bgp vpnv4 vrf <vrfName> <prefix> <subnetMask>

34. show ip bgp vpnv4 vrf <vrfName> labels | include <networkPrefix>/<subnetMask> | [0-9]+\.[0-9]+\.[0-9]+\.[0-9]+

35. show ip bgp vpnv4 vrf <vrfName> labels | include <classfulPrefix>

36. show ip bgp vpnv4 vrf <vrfName> labels | include <networkPrefix>/<subnetMask>

37. show ip cef <destinationPrefix>

38. show ip cef summary

39. show ip cef vrf <vrfName> <networkPrefix> <subnetMask> detail

40. show ip cef vrf <vrfName> <networkPrefix> detail

41. show ip cef vrf <vrfName> adjacency <interface> <destip> detail

42. show ip eigrp <vrfName> interfaces <vrfInterface>

43. show ip interface <interface>

44. show ip interface <interface> | include access list is

45. show ip interface brief <interface>

46. show ip ospf <processId> <area> interface <intName>

47. show ip protocols <vrfName>

48. show ip route <targetIp>

49. show ip route vrf <vrfName> <targetIp>

50. show ip traffic

51. show ip vrf detail <vrfName>

52. show ip vrf interfaces <vrfName>

53. show mpls forwarding-table <destinationPrefix>

54. show mpls forwarding-table <destinationPrefix> <subnetMask>

55. show mpls forwarding-table <destinationPrefix> detail

56. show mpls forwarding-table labels <label>

57. show mpls forwarding-table labels <label> detail

58. show mpls forwarding-table vrf <vrfName>

59. show mpls forwarding-table vrf <vrfName> <destinationPrefix>

60. show mpls forwarding-table

61. show mpls interfaces <interface>

62. show mpls interfaces all

63. show mpls ip binding <destinationPrefix> <destinationMask>

64. show mpls ip binding local

65. show mpls ip binding summary

66. show mpls label range

67. show mpls ldp bindings <ip> <subnetMask>

68. show mpls ldp bindings neighbor <neighbor ip> <subnetMask>

69. show mpls ldp discovery

70. show mpls ldp neighbor

71. show mpls ldp neighbor <interface>

72. show mpls traffic-eng tunnels

73. show mpls traffic-eng tunnels <status>

74. show mpls traffic-eng tunnels <tunnelId>

75. show mpls traffic-eng tunnels destination <destination> <status>

76. show mpls traffic-eng tunnels destination <destination>

77. show mpls traffic-eng tunnels role <role>

78. show mpls traffic-eng tunnels role <role> <status>

79. show mpls traffic-eng tunnels role <role> destination <destination> <status>

80. show mpls traffic-eng tunnels role <role> destination <destination> up

81. show ppp multilink interface <interface>

82. show route-map <mapName>

83. show running-config

84. show running-config interface <interface>

85. show running-config interface <interface> | include frame-relay interface-dlci

86. show running-config interface <interface> | include map-group

87. show running-config interface <interface> | include no frame-relay inverse-arp

88. show running-config | begin router bgp

89. show running-config | include advertise-

90. show running-config | include ldp password

91. show running-config | include mpls label protocol

92. show running-config | include no

93. show version

94. show vlans

95. traceroute mpls ipv4 <ipAddress>/<subnetMask> source <source> destination <destination> ttl 15

96. traceroute mpls traffic-eng Tunnel <tunnelNumber>

97. traceroute vrf <vrfName> (interactive)

3.3  IOS XR Commands

This section lists the IOS XR commands used by MDE. If TACACS+ (or another authentication/authorization system) is used, ensure that these are all allowed for MDE.

Note This list might be updated when MDE releases or patches are made available, e-mail: mpls-diagnostics-expert@cisco.com for the latest list.

1. ping <targetIp>

2. ping atm interface <interface> <vpi>/<vci>

3. ping atm interface <interface> <vpi>/<vci> end-loopback

4. ping atm interface <interface> <vpi>/<vci> seg-loopback

5. ping mpls ipv4 <destination>/<subnetMask>

6. ping mpls ipv4 <destination>/<subnetMask> reply mode router-alert

7. ping mpls ipv4 <destination>/<subnetMask> source <source>

8. ping mpls traffic-eng Tunnel <tunnelId>

9. ping vrf <vrfName>

10. ping vrf <vrfName> <targetIp> <sourceInterface> <minSweepSize> <maxSweepSize> <sweepInterval>

11. show access-lists ipv4 <listName>

12. show bgp ipv4 all summary

13. show bgp vpnv4 unicast neighbors

14. show bgp vpnv4 unicast summary

15. show bgp vpnv4 unicast vrf <vrfName> <prefix> <mask>

16. show bgp vpnv4 unicast vrf <vrfName> labels

17. show bgp vrf <vrfName> neighbors

18. show bgp vrf <vrfName> vpnv4 unicast neighbors

19. show cef ipv4 <destinationPrefix>

20. show cef ipv4 drops

21. show cef ipv4 drops location <slot>

22. show cef ipv4 summary

23. show cef vrf <vrfName> ipv4 <networkPrefix> detail

24. show cef vrf <vrfName> ipv4 <networkPrefix> <subnetMask> detail

25. show cef vrf <vrfName> <networkPrefix> <subnetMask> location <location>

26. show eigrp <vrfName> interfaces <vrfInterface>

27. show frame-relay lmi

28. show frame-relay lmi interface <interface>

29. show install active summary

30. show install inactive summary

31. show install location <slot>

32. show interfaces <interface>

33. show ip cef vrf <vrfName> adjacency <interface> <destip> detail

34. show ip ospf <processId> <area> interface <intName>

35. show ipv4 interface <interface>

36. show ipv4 interface brief <interface>

37. show ipv4 traffic

38. show ipv4 vrf <vrfName> interface brief

39. show ipv4 vrf <vrfName> interface <interface>

40. show ipv4 vrf all interface brief

41. show mpls forwarding

42. show mpls forwarding labels <label>

43. show mpls forwarding prefix <destinationPrefix>/<subnetMask>

44. show mpls forwarding prefix <destinationPrefix>/<subnetMask> detail

45. show mpls forwarding vrf <vrf>

46. show mpls forwarding vrf <vrf> prefix <destinationPrefix>/<subnetMask>

47. show mpls forwarding vrf <vrfName> prefix <destinationPrefix>/<subnetMask> labels <label> location <location>

48. show mpls forwarding vrf <vrfName> prefix <destinationPrefix>/<subnetMask> location <location>

49. show mpls interfaces

50. show mpls interfaces <interface>

51. show mpls label range

52. show mpls label table summary

53. show mpls ldp bindings <ip> <mask>

54. show mpls ldp bindings neighbor <neighbor> <ip> <mask>

55. show mpls ldp discovery

56. show mpls ldp neighbor

57. show mpls ldp neighbor <interface>

58. show mpls traffic-eng tunnels

59. show mpls traffic-eng tunnels <status> detail

60. show mpls traffic-eng tunnels <tunnelNumber> detail

61. show mpls traffic-eng tunnels destination <destination> <status> detail

62. show mpls traffic-eng tunnels destination <destination> detail

63. show mpls traffic-eng tunnels detail

64. show mpls traffic-eng tunnels role <role> <status> detail

65. show mpls traffic-eng tunnels role <role> destination <destination> <status> detail

66. show mpls traffic-eng tunnels role <role> destination <destination> up detail

67. show mpls traffic-eng tunnels role <role> detail

68. show rib ipv4 tables

69. show route ipv4 <targetIp>

70. show route vrf <vrfName> ipv4 <targetIp>

71. show rpl route-policy <mapName>

72. show running-config

73. show running-config interface <interface>

74. show running-config mpls ldp label advertise

75. show running-config router bgp

76. show vlan interface

77. show version

78. show vrf <vrfName> ipv4 detail

79. traceroute mpls ipv4 <destination>/<subnetMask>

80. traceroute mpls traffic-eng Tunnel <tunnelId>

81. traceroute vrf <vrf>