Table Of Contents

SA Agent Feature Mapping

Verify Your SA Agent Version

SA Agent Feature Mapping

---

This appendix lists the IPM operations supported in different versions of SA Agent versions. This section also provides the procedure to verify whether SA Agent is running on your Cisco IOS software.

Table C-1 lists the IPM operations supported in different versions of Cisco IOS releases:

Table C-1 IPM Operations Mapped to SA Agent Version 

Operations1	SAA Version
DLSw	2.1.0
DHCP2	2.1.0
DNS	2.1.0
HTTP	2.1.0
IP PathEcho	2.1.0
ICMP Echo	1.0.1
Jitter	2.1.0
TCP Connect	2.1.0
SNAEcho	2.1.0
SSCPEcho	2.1.0
SNA LU0 Echo	1.0.1
SNA LU2 Echo	1.0.0
UDP	2.1.0
FTP	2.2.0

1 RTR Responder is supported from SAA 2.1.0 version. 2 Server support for 2.2.0

Verify Your SA Agent Version

On your device run the command:

show rtr application

The expected output on your device is:

Version: 2.2.0 Round Trip Time MIB

Max Packet Data Size (ARR and Data): 16384

Time of Last Change in Whole RTR: *17:23:28.000 UTC Sun Mar 21 1993

System Max Number of Entries: 500

Number of Entries configured: 12

Number of active Entries: 12

Number of pending Entries: 0

Number of inactive Entries: 0

Supported Operation Types

Type of Operation to Perform:  echo

Type of Operation to Perform:  pathEcho

Type of Operation to Perform:  udpEcho

Type of Operation to Perform:  tcpConnect

Type of Operation to Perform:  http

Type of Operation to Perform:  dns

Type of Operation to Perform:  jitter

Type of Operation to Perform:  dlsw

Type of Operation to Perform:  dhcp

Type of Operation to Perform:  ftp

Supported Protocols

Protocol Type: ipIcmpEcho

Protocol Type: ipUdpEchoAppl

Protocol Type: snaRUEcho

Protocol Type: snaLU0EchoAppl

Protocol Type: snaLU2EchoAppl

Protocol Type: ipTcpConn

Protocol Type: httpAppl

Protocol Type: dnsAppl

Protocol Type: jitterAppl

Protocol Type: dlsw

Protocol Type: dhcp

Protocol Type: ftpAppl

Number of configurable probe is 483

RTR low memory water mark: 3531486

From the output, Version refers to the SAA version that is running on your device. In addition to this, you get information about:

•IPM operations that are supported

•Protocols that are supported

•Number of collectors that are configured

•Number of collectors that can be configured