Table Of Contents

Digital Subscriber Line (DSL) and Integrated Services Digital Network (ISDN)

Technology Description

xDSL

ISDN

Inventory and Information Model Objects (IMOs)

Digital Subscriber Line Interface

Asynchronous Digital Subscriber Line Interface

Asynchronous Digital Subscriber Line 2 Interface

DSL Traffic Descriptor

Asynchronous DSL Traffic Descriptor

Asynchronous DSL 2 Spectrum Traffic Descriptor

Synchronous DSL Traffic Descriptor

Synchronous High Bit Rate DSL Traffic Descriptor

Integrated Services Digital Network (ISDN) Interface

Integrated Services Digital Network (ISDN) Channel

Integrated Services Digital Network (ISDN) Physical

Vendor Specific Inventory and Information Model Objects

ECI's HiFocus ADSL Traffic Descriptor

Alcatel's ASAM SHDSL Traffic Descriptor

Network Topology

Service Alarms

Digital Subscriber Line (DSL) and Integrated Services Digital Network (ISDN)

---

This chapter describes the level of support that Cisco ANA provides for DSL and ISDN, as follows:

•Technology Description

•Inventory and Information Model Objects (IMOs)

•Vendor Specific Inventory and Information Model Objects

•Network Topology

•Service Alarms

Technology Description

xDSL

Digital Subscriber Line (DSL) technology is a modem technology that uses existing twisted pair telephone lines to transport high bandwidth data, such as multimedia and video, to service subscribers. The term xDSL covers a number of similar yet competing forms of DSL, including Asymmetric DSL (ADSL/ADSL2), Symmetric DSL (SDSL), High Speed DSL (HDSL), Rate Adaptive (RADSL), and Very High Bit Data Rate DSL (VDSL) for delivering up to 52 Mbps downstream.

At the customer end of the connection a DSL modem converts data from the digital signals used by computers into a voltage signal of a suitable frequency range which is then applied to the phone line. At the exchange end, a Digital Subscriber Line Access Multiplexer (DSLAM) terminates the DSL circuits and aggregates them, where they are handed off onto other networking transports. In the case of ADSL, the voice component is also separated at this step, either by a filter integrated in the DSLAM or by specialized filtering equipment installed before it.

ISDN

Integrated Services Digital Network (ISDN) is comprised of digital telephony and data transport services offered by regional telephone carriers. ISDN involves the digitization of the telephone network, which permits voice, data, text, graphics, music, video, and other source material to be transmitted over existing telephone wires.

There are two type of channel in ISDN: A 64 Kbps Bearer (B) channel, which used for data and up to 64 Kbps Delta (D) channel used for signalling and control over the Layers 1 through 3 of the OSI reference model.

With those there are two types of services associated: The 192Kbps Basic Rate Interface (BRI) service, which offers two B channels and one D channel (2B+D) and the 1.544/2.048 Mbps Primary Rate Interfaces (PRI) service, which offers 23/31 B channels and one D channel respectively for the xDSL interface backup.

Inventory and Information Model Objects (IMOs)

This section includes the following tables:

•Digital Subscriber Line Interface (IDsl/IIdsl/ISdsl/IShdsl)

•Asynchronous Digital Subscriber Line Interface (IADsl)

•Asynchronous Digital Subscriber Line 2 Interface (IADsl2)

•ISDN DSL Traffic Descriptor (IIdslTrafficDescriptor)

•Asynchronous DSL Traffic Descriptor (IAdslTrafficDescriptor)

•Asynchronous DSL 2 Spectrum Traffic Descriptor (IAdsl2TrafficDescriptor)

•Synchronous DSL Traffic Descriptor (ISdslTrafficDescriptor)

•Synchronous High Bit Rate DSL Traffic Descriptor (IShdslTrafficDescriptor)

•Integrated Services Digital Network Interface (IIsdnLayer2)

•Integrated Services Digital Network Channel (IIsdnChannel)

•Integrated Services Digital Network Physical (IIsdnLayer1)

Digital Subscriber Line Interface

The following Physical layer Digital Subscriber Line Interface, which represents any DSL interface, as well as Asynchronous Digital Subscriber Line Interface and Asynchronous Digital Subscriber Line 2 Interface objects, are bound by their Containing Termination Points attribute to a Port Connector object, and is primarily accessed by only a Data Link Layer ATM Interface bound by its Contained Connection Termination Points attribute.

Table 10-1 Digital Subscriber Line Interface (IDsl/IIdsl/ISdsl/IShdsl) 

Attribute Name	Attribute Description	Scheme	Polling Interval
Modulation Type	Modulation type (Null, DMT, CAP, QAM, GLite, GDMT, 2B1Q)	Product	Configuration
Customer Identification	Customer identification	Product	Configuration
Traffic Descriptor	Traffic descriptor (DSL Traffic Descriptor)	Product	Configuration
Same as Physical Layer (IPhysicalLayer)

Asynchronous Digital Subscriber Line Interface

Table 10-2 Asynchronous Digital Subscriber Line Interface (IADsl)

Attribute Name	Attribute Description	Scheme	Polling Interval
Maximum Reception and Transmission Bandwidth	Maximum reception and transmission bandwidth	Product	Configuration
Same as Digital Subscriber Line Interface (IDsl)

Asynchronous Digital Subscriber Line 2 Interface

Table 10-3 Asynchronous Digital Subscriber Line 2 Interface (IADsl2)

Attribute Name	Attribute Description	Scheme	Polling Interval
Spectrum Traffic Descriptor	Spectrum traffic descriptor (Asynchronous DSL 2 Spectrum Traffic Descriptor)	Product	Configuration
Traffic Descriptor	Traffic descriptor (Asynchronous DSL Traffic Descriptor)	Product	Configuration
Same as Asynchronous Digital Subscriber Line Interface (IADsl)

DSL Traffic Descriptor

The following various DSL Traffic Descriptor objects describe the traffic of various standard DSL Interfaces and are being aggregated by a Traffic Descriptor Container object (see Common Components).

Table 10-4 ISDN DSL Traffic Descriptor (IIdslTrafficDescriptor)

Attribute Name	Attribute Description	Scheme	Polling Interval
Target Bit Rate	Target Bit rate	Product	Configuration
Name	Traffic descriptor name	Product	Configuration
Index	Traffic descriptor index	Product	Configuration

Asynchronous DSL Traffic Descriptor

Table 10-5 Asynchronous DSL Traffic Descriptor (IAdslTrafficDescriptor) 

Attribute Name	Attribute Description	Scheme	Polling Interval
Maximum, Minimum and Target Transmission and Reception Noise Margins	Maximum, minimum and target transmission and reception noise margins	Product	Configuration
Maximum, Minimum and Planned Transmission and Reception Bit Rates	Maximum, minimum and planned transmission and reception Bit rates	Product	Configuration
Maximum Transmission Power Spectral Density	Maximum transmission Power Spectral Density (PSD)	Product	Configuration
Transmission and Reception Rate Adaptation	Transmission and reception rate adaptation mode (Null, Fixed, Adapt at Startup, Adapt at Runtime)	Product	Configuration
Channel Type	ADSL channel type (Null, Fast, Interleaved, Fast or Interleaved, Fast and Interleaved)	Product	Configuration
Name	Traffic descriptor name	Product	Configuration
Index	Traffic descriptor index	Product	Configuration

Asynchronous DSL 2 Spectrum Traffic Descriptor

Table 10-6 Asynchronous DSL 2 Spectrum Traffic Descriptor (IAdsl2TrafficDescriptor)

Attribute Name	Attribute Description	Scheme	Polling Interval
Maximum, Minimum and Target Transmission and Reception Noise Margins	Maximum, minimum and target transmission and reception noise margins	Product	Configuration
Name	Traffic descriptor name	Product	Configuration
Index	Traffic descriptor index	Product	Configuration

Synchronous DSL Traffic Descriptor

Table 10-7 Synchronous DSL Traffic Descriptor (ISdslTrafficDescriptor)

Attribute Name	Attribute Description	Scheme	Polling Interval
Target and Minimum Bit Rate	Target and minimum line Bit rate	Product	Configuration
Target Noise Margin	Target noise margin	Product	Configuration
Name	Traffic descriptor name	Product	Configuration
Index	Traffic descriptor index	Product	Configuration

Synchronous High Bit Rate DSL Traffic Descriptor

Table 10-8 Synchronous High Bit Rate DSL Traffic Descriptor (IShdslTrafficDescriptor) 

Attribute Name	Attribute Description	Scheme	Polling Interval
Target Bit Rate	Target line Bit rate	Product	Configuration
Wire Mode	Wire mode (Null, Two Wire, Four Wire)	Product	Configuration
Spectral Mode	Spectral mode (Null, Symmetric, Asymmetric)	Product	Configuration
Name	Traffic descriptor name	Product	Configuration
Index	Traffic descriptor index	Product	Configuration

Integrated Services Digital Network (ISDN) Interface

The following Data Link layer Integrated Services Digital Network (ISDN) Interface object, is bound by its Containing Termination Points attribute to a Physical Layer Integrated Services Digital Network (ISDN) Physical object, and is primarily accessed by Point To Point Protocol Encapsulation bound by its Contained Connection Termination Points attribute.

Table 10-9 Integrated Services Digital Network Interface (IIsdnLayer2)

Attribute Name	Attribute Description	Scheme	Polling Interval
Control Administrative Status	Administrative status (Unknown, Up, Down, Testing)	Product	Status
Operational Status	Operational status (Unknown, Up, Down, Testing, Dormant, Not Present)	Product	Status
Channels Table	Array of Integrated Services Digital Network (ISDN) Channels	Product	Configuration
IANA Type	IANA type of the sub/layer	N/A	N/A
Containing Termination Points	Underlying termination points (connection or physical)	Product	N/A
Contained Connection Termination Points	Bound Connection Termination Points	Product	N/A

Integrated Services Digital Network (ISDN) Channel

The following Data Link layer Integrated Services Digital Network (ISDN) Channel object describes an Integrated Services Digital Network (ISDN) Interface channels table's entry.

Table 10-10 Integrated Services Digital Network Channel (IIsdnChannel)

Attribute Name	Attribute Description	Scheme	Polling Interval
Control Administrative Status	Administrative status (Unknown, Up, Down, Testing)	Product	Status
Operational Status	Operational status (Unknown, Up, Down, Testing, Dormant, Not Present)	Product	Status

Integrated Services Digital Network (ISDN) Physical

The following Physical layer Integrated Services Digital Network (ISDN) Physical object, is bound by its Containing Termination Points attribute to a Port Connector object, and is accessed by the Data Link layer Integrated Services Digital Network (ISDN) Interface bound by its Contained Connection Termination Points attribute.

Table 10-11 Integrated Services Digital Network Physical (IIsdnLayer1)

Attribute Name	Attribute Description	Scheme	Polling Interval
Same as Physical Layer (IPhysicalLayer)

Vendor Specific Inventory and Information Model Objects

Vendor specific Information Model Objects are implemented only for specific devices of the vendor.

The following vendors' DSL Traffic Descriptor objects describe traffic of these vendors' standard DSL interfaces, and are aggregated by a Traffic Descriptor Container object.

•ECI's HiFocus ADSL Traffic Descriptor

•Alcatel's ASAM SHDSL Traffic Descriptor

ECI's HiFocus ADSL Traffic Descriptor

Table 10-12 ECI's HiFocus ADSL Traffic Descriptor (IECIHiFocusAdslTrafficDescriptor)

Attribute Name	Attribute Description	Scheme	Polling Interval
Discrete Multi-Tone Coding Model	Discrete multi-tone coding model (Null, discrtMultiTone)	Product	Configuration
ATUC Downstream and ATUR Upstream Usage	ATUC downstream and ATUR upstream usage (Null, Yes, No)	Product	Configuration
ATUC Downstream Fast and Interleave Check Bytes	ATUC downstream fast and interleave check bytes	Product	Configuration
ATUR Upstream Fast and Interleave Check Bytes	ATUR upstream fast and interleave check bytes	Product	Configuration
ATUC Downstream and ATUR Upstream Interleaved Depth	ATUC downstream and ATUR interleaved depth (Power of 2, 0, Non)	Product	Configuration
ATUC Downstream and ATUR Upstream Code Word Length	ATUC downstream and ATUR upstream code word length in symbols per code word	Product	Configuration
Trellis Coded Modulation Option Usage	Trellis coded modulation option usage (Null, Enabled, Disabled)	Product	Configuration
Echo Cancellation Option	Echo cancellation option (Null, Enabled, Disabled)	Product	Configuration
Coding Mode	Coding mode (Null, Automatic, Manual)	Product	Configuration
Same as Asynchronous DSL Traffic Descriptor (IAdslTrafficDescriptor) - see Table 10-5.

Alcatel's ASAM SHDSL Traffic Descriptor

Table 10-13 Alcatel's ASAM SHDSL Traffic Descriptor (IAlcatelAsamShdslTrafficProfile)

Attribute Name	Attribute Description	Scheme	Polling Interval
Minimum and Maximum Required Bit Rate	Minimum and maximum required Bit rate	Product	Configuration
Same as Synchronous High Bit Rate DSL Traffic Descriptor (IShdslTrafficDescriptor) - see Table 10-8.

Network Topology

The Digital Subscriber Line (DSL) Physical layer topology is unsupported and is manually (statically) configured by the system administrator.

Service Alarms

The following alarms are supported for this technology:

•Link Down/Link Up

•Port Down/Port Up

---

Note For a detailed description of these alarms and for information about correlation see the Cisco Active Network Abstraction Fault Management User Guide.

---