Table Of Contents
Cisco ANA Installation Workflow
Cisco ANA Installation Workflow
This chapter provides a workflow of the steps required to install Cisco Active Network Abstraction (Cisco ANA) version 3.6 Service Pack 2.
Service Pack 2 is installed on top of Service Pack 1 which must be installed on top of a Cisco ANA 3.6 installation. If Cisco ANA 3.6 is already installed on your system, you must install Service Pack 1, and then Service Pack 2. If Service Pack 1 is already installed, you need only install Service Pack 2.
Figure 3-1 describes the overall steps required to install Cisco ANA 3.6 Service Pack 2. Detailed instructions on how to perform each step are provided in subsequent chapters.
Figure 3-1 Cisco ANA Installation Workflow
Step 1 
Install Oracle 9i or Oracle 10g for use with Cisco ANA 3.6 installation with Service Pack 1 and 2. For instructions, see Chapter 4, "Oracle Server Installation".
Step 2 Install Cisco ANA 3.6, as follows:
•If you are installing Cisco ANA 3.6 for the first time, follow the instructions described in Chapter 5, "Installing a Gateway", and Chapter 6, "Installing a Unit".
•If you are upgrading to Cisco ANA 3.6 from an earlier version of Cisco ANA, follow the instructions described in Chapter 10, "Upgrading Cisco ANA".
Step 3 Install Service Pack 1 on the gateway and units. For instructions, see Chapter 7, "Installing the Service Packs".
Step 4 Install Service Pack 2 on the gateway and units. For instructions, see Chapter 7, "Installing the Service Packs".
Step 5 Install the required client applications. For instructions, see Chapter 8, "Installing a Client".
