Table Of Contents

File System Debug Commands on Cisco IOS XR Software

debug filecopy

File System Debug Commands on Cisco IOS XR Software

---

This chapter describes the commands used to debug the file system on Cisco IOS XR software.

---

Caution Because debugging output is assigned high priority in the CPU process, it can render the system unusable. For this reason, use debug commands only to troubleshoot specific problems or during troubleshooting sessions with Cisco technical support staff. Moreover, it is best to use debug commands during periods of lower network traffic and fewer users. Debugging during these periods decreases the likelihood that increased debug command processing overhead will affect system use.

---

debug filecopy

To enable debugging of the file copy process, use the debug filecopy command in EXEC mode. To turn off the debugging output, use the no form of this command.

debug filecopy bag {all | gets | sets}

no debug filecopy bag {all | gets | sets}

Syntax Description

bag	Specifies filecopy bag operations.
all	Specifies filecopy bag all.
gets	Specifies filecopy bag gets.
sets	Specifies filecopy bag sets.

Defaults

No default behavior or values

Command Modes

EXEC

Command History

Release	Modification
Release 2.0	This command was introduced on the Cisco CRS-1.
Release 3.0	No modification.
Release 3.2	This command was supported on the Cisco XR 12000 Series Router.
Release 3.3.0	No modification.
Release 3.4.0	No modification.
Release 3.5.0	No modification.
Release 3.6.0	No modification.
Release 3.7.0	No modification.
Release 3.8.0	No modification.

Usage Guidelines

To use this command, your Cisco IOS XR software system administrator must assign you to a user group associated with a task group that includes the corresponding command task IDs. If you need assistance with your task group assignment, contact your system administrator. For detailed information about user groups and task IDs, see the Configuring AAA Services on Cisco IOS XR Software module of Cisco IOS XR System Security Configuration Guide.

Debugging output is assigned high priority in the CPU process and, therefore, can affect system performance. For more information about the impact on system performance when using debug commands, refer to Using Debug Commands on Cisco IOS XR Software.

Task ID

Task ID	Operations
basic-services	read, write

Examples

The following example shows how to enable file copy process debugging:

RP/0/RP0/CPU0:router# debug filecopy bag all