Table Of Contents

Layer 1 Messages

SPA_OC48 Messages

Layer 1 Messages

---

This section contains all Layer 1 related System Error Messages. The following facility codes are represented in this module:

•SPA_OC48 Messages

SPA_OC48 Messages

Error Message     

%L1-SPA_OC48-3-ERR_INIT SPA driver initialization failed in bay [dec]: ([chars]/[chars]).

Explanation    The SPA driver on the linecard failed to initialize. The SPA driver controls all the hardware on the SPA. If the SPA driver fails to initialize, no traffic will pass, no SPA related infrastructure will work. %d - SPA bay number %s - indicates the reason for the failure %s - is the decoded error reason

Recommended Action    The SPA infra will automatically restart the SPA driver, up to a fixed number of times when this error is encountered, to recover. Execute 'show platform' to verify the SPA is in READY state, if not, try to reload the SPA with command: hw-module subslot 0/x/x reload or if the system has no response to the command above, force to reload the SPA with follwoing sequence under config mode: hw-module subslot 0/x/x shutdown commit no hw-module subslot 0/x/x shutdown commit If the message recurs, copy the error message exactly as it appears on the console or in the system log, call your Cisco technical support representative and provide the representative with the gathered information.

Error Message     

%L1-SPA_OC48-3-ERR_SFP_OIR SFP OIR error in bay [dec]: ([chars]/[chars]).

Explanation    There is an error detected during SFP OIR. SFP is the pluggable optics on the SPA, SFP OIR can cause some operation in sw, e.g. create/delete optics object, SFP authentication. 'SFP OIR error' is for any possible error during the operation. The optics will not work if SFP OIR operation failed, therefore no traffic can pass. %d - SPA bay number %s - indicates the reason for the failure %s - is the decoded error reason

Recommended Action    - Check the SFP, make sure it is CISCO certified; - Try to do the SFP OIR for a few more times; - If the issue persists, reload the SPA with the command: hw-module subslot 0/x/x reload then test SFP OIR after SPA comes up. If the message recurs, copy the error message exactly as it appears on the console or in the system log, call your Cisco technical support representative and provide the representative with the gathered information.

Error Message     

%L1-SPA_OC48-6-OPTICS_INSERTION Optics module inserted into SPA in bay [dec], port [dec]

Explanation    Optics module has inserted %d - bay number %d - port number

Recommended Action    none

Error Message     

%L1-SPA_OC48-6-OPTICS_REMOVAL Optics module removed from SPA in bay [dec], port [dec]

Explanation    Optics module has removed %d - bay number %d - port number none