Table Of Contents
Manageability (MGBL) Messages
IPSLA_TS_SVR Messages
NFEA_HW_PROG Messages
Manageability (MGBL) Messages
This section contains all Management Plane and Manageability related System Error Messages, including config, cli, sml, pm, and so forth. The following facility codes are represented in this module:
•
IPSLA_TS_SVR Messages
•
NFEA_HW_PROG Messages
IPSLA_TS_SVR Messages
Error Message
%MGBL-IPSLA_TS_SVR-3-EVENT
Error while processing event ([chars])
Explanation An error occurred while processing an event at the time stamp server event manager
Recommended Action This is an unusual situation which should not occur under normal
circumstances. If the situation persists it may require the restart of the time stamping process.
Error Message
%MGBL-IPSLA_TS_SVR-3-INIT
Failed to initialize [chars]:[chars]
Explanation Time stamp server failed to perform initialization task. The initialization step where it
failed and the exact error are mentioned in the message.
Recommended Action This could happen in a fatal situation. Such as system low on resources or
communication failures. Copy the error message exactly as it appears on the console or in the system
log. Issue the show tech-support command to gather data that may provide information to
determine the nature of the error. If you cannot determine the nature of the error from the error
message text or from the show tech-support output, call your Cisco technical support
representative and provide the representative with the gathered information.
NFEA_HW_PROG Messages
Error Message
%MGBL-NFEA_HW_PROG-7-ERR_MSG
[chars]
Explanation During initialization, an internal error occurred in Netflow which involves exiting the
process.
Recommended Action When this issue happens, it will trigger an automatic restart. If the message
recurs, copy the error message exactly as it appears on the console or in the system log, call your
Cisco technical support representative and provide the representative with the gathered information.