Table Of Contents

Cisco Unified Border Element SIP Support

Finding Feature Information

Cisco Unified Border Element SIP Support Features

Cisco Unified Border Element SIP Support

---

Revised: October 20, 2010

First Published: November 25, 2009

Last Updated: October 20, 2010

This Cisco Unified Border Element is a special Cisco IOS software image that provides a network-to-network interface point for billing, security, call admission control, quality of service, and signaling interworking. This chapter describes basic gateway functionality, software images, topology, and summarizes supported features.

---

Activation Cisco Product Authorization Key (PAK)—A Product Authorization Key (PAK) is required to configure some of the features described in this guide. Before you start the configuration process, please register your products and activate your PAK at the following URL http://www.cisco.com/go/license.

---

Finding Feature Information

For the latest feature information and caveats, see the release notes for your platform and software release. To find information about the features documented in this module, and to see a list of the releases in which each feature is supported, see the "Cisco Unified Border Element Features Roadmap" section on page 3.

Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not required.

Cisco Unified Border Element SIP Support Features

This chapter contains the following configuration topics:

Cisco UBE Prerequisites and Restrictions

•Prerequisites for Cisco Unified Border Element

•Restrictions for Cisco Unified Border Element

Basic SIP Set-up

•SIP—Core SIP Technology Enhancements

SIP Parameter Settings

•SIP—Configurable Hostname in Locally Generated SIP Headers

•SIP Parameter Modification

•SIP—Session Timer Support

SIP Protocol Handling and Supplementary Services

•SIP-to-SIP Basic Functionality for Session Border Controller

•SIP-to-SIP Extended Feature Functionality for Session Border Controllers

•SIP-to-SIP Supplementary Services for Session Border Controller

•Cisco UBE Support for generating Out-of-dialog SIP OPTIONS Ping messages to monitor SIP Servers

•SIP—INFO Method for DTMF Tone Generation

•SIP—Enhanced 180 Provisional Response Handling

•Configuring Support for SIP 181 Call is Being Forwarded Message

•Support for Expires Timer Reset on Receiving or Sending SIP 183 Message

•Support for PAID, PPID, Privacy, PCPID, and PAURI Headers on the Cisco UBE

•Configuring Selective Filtering of Outgoing Provisional Response on the Cisco UBE

•Cisco Unified Border Element Support for Configurable Pass-through of SIP INVITE Parameters

•Transparent Tunneling of QSIG and Q.931 over SIP TDM Gateway and SIP-SIP Cisco Unified Border Element

•SIP Diversion Header Enhancements

SIP Registration & Authentication

•SIP—Ability to Send a SIP Registration Message on a Border Element

•Support for Multiple Registrars on SIP Trunks

SIP Normalization

•SIP Parameter Modification

Additional References

Glossary

Feature Information for Cisco UBE SIP Support,