Table Of Contents

Inbound Dial-Peer to Match the URI on SIP Calls

Prerequisites

Configuring an Inbound Dial-Peer to Match the URI on SIP Call

Inbound Dial-Peer to Match the URI on SIP Calls

The Inbound Dial-Peer to Match the URI on SIP Calls feature expands the inbound dial-peer matching logic to include matching based on the source IP address of inbound signaling on a SIP trunk. This feature enables enforcement of specific call-treatment, security and routing policies on each SIP trunk.

Prerequisites

Cisco Unified Border Element

•Cisco IOS Release 15.0(1)M or a later release must be installed and running on your Cisco Unified Border Element.

Cisco Unified Border Element (Enterprise)

•Cisco IOS XE Release 3.1S or a later release must be installed and running on your Cisco ASR 1000 Series Router.

Configuring an Inbound Dial-Peer to Match the URI on SIP Call

To enable this feature, see the "Configuring an Inbound Dial-Peer to Match the URI on SIP Calls" section in the Cisco IOS Tcl IVR and VoiceXML Application Guide - 12.3(14)T and later . Detailed Command reference information is located in the Cisco IOS Voice Command Reference.