Cisco IOS XE Interface and Hardware Component Configuration Guide, Release 2
Configuring Physical Interfaces

Table Of Contents

Configuring Physical Interfaces

Configuration Information

Command Reference Information


Configuring Physical Interfaces


First Published: May 12, 2009
Last Updated: May 12, 2009

The Cisco ASR 1000 Series Aggregation Services Routers support many different types of physical (hardware) interfaces such as Gigabit Ethernet, Packet over SONET (POS), and serial shared port adapter (SPA) interfaces. For hardware technical descriptions and information about installing interfaces, refer to the hardware installation and configuration publication for your product.

Configuration Information

For information about using the Gigabit Ethernet Management Ethernet interface, see the "Using the Management Ethernet Interface" chapter of the Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide at:

http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/chassis/asrswcfg.html

For information about configuring and troubleshooting SPA interface processors (SIPs) and SPAs that are supported on a Cisco ASR 1000 Series Aggregation Services Router, see the Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide at:

http://cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/ASR1000/ASRspasw.html

Command Reference Information

Complete descriptions of the commands used to configure interfaces are included in the Cisco IOS Interface and Hardware Component Command Reference at:

http://www.cisco.com/en/US/docs/ios/interface/command/reference/ir_book.html

For information about other Cisco IOS XE commands, use the Command Lookup Tool at http://tools.cisco.com/Support/CLILookup or the Cisco IOS Master Command List, All Releases, at http://www.cisco.com/en/US/docs/ios/mcl/allreleasemcl/all_book.html.