Cisco IOS Quality of Service Solutions Command Reference, Release 12.3 - Introduction for the QoS Command Reference, 12.3 [Cisco IOS Software Releases 12.3 Mainline]

	Cisco IOS Quality of Service Solutions Command Reference, Release 12.3
	Introduction for the QoS Command Reference, 12.3
Cisco IOS Quality of Service Solutions Command Reference, Release 12.3 Introduction for the QoS Command Reference, 12.3 Quality of Service Commands, 12.3: a through f Quality of Service Commands, 12.3: ip nbar pdlm through ip rtp priority Quality of Service Commands, 12.3: m through n Quality of Service Commands, 12.3: o through p Quality of Service Commands, 12.3: q through r Quality of Service Commands 12.3: send qdm message through show ip nbar pdlm Quality of Service Commands, 12.3: show ip nbar port-map through show qdm status Quality of Service Commands, 12.3: show queue through vc-hold-queue	Download this chapter Introduction for the QoS Command Reference, 12.3 Table Of Contents Introduction Introduction Quality of service (QoS) commands are used to configure quality of service, a measure of performance for a transmission system that reflects its transmission quality and service availability. For QoS configuration information and examples, refer to the Cisco IOS Quality of Service Solutions Configuration Guide.
	© 1992-2008 Cisco Systems, Inc. All rights reserved. Terms & Conditions \| Privacy Statement \| Cookie Policy \| Trademarks of Cisco Systems, Inc.

Table Of Contents