IKE Responder-Only Mode
|
|||||||||||
Contents
IKE Responder-Only ModeLast Updated: May 19, 2011
The IKE Responder-Only Mode feature provides support for controlling the initiation of Internet Key Exchange (IKE) negotiation and rekeying. When a device is configured as a responder-only device, it will not initiate IKE main, aggressive, or quick modes (for IKE and IP security [IPsec] security association [SA] establishment) nor will it rekey IKE and IPsec SAs. The device will respond to any negotiations initiated by its peers.
Finding Feature InformationYour software release may not support all the features documented in this module. For the latest feature information and caveats, see the release notes for your platform and software release. To find information about the features documented in this module, and to see a list of the releases in which each feature is supported, see the Feature Information Table at the end of this document. Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required. Prerequisites for IKE Responder-Only Mode
Information About IKE Responder-Only ModeBenefits of the IKE Responder-Only Mode FeatureSince the advent of virtual private network (VPN) features that allow simultaneous bidirectional IKE negotiations (with or without interesting traffic), issues with the handling and recovery of data from duplicate IKE SAs have occurred. IKE as a protocol has no ability to compare IKE negotiations to determine whether there is already an existing or in-process negotiation between two peers taking place. These duplicate negotiations can be costly in terms of resources and confusing to router administrators. When a device is configured as a responder-only device, it will not initiate IKE main, aggressive, or quick modes (for IKE and IPsec SA establishment), nor will it rekey IKE and IPsec SAs, thus the likelihood of duplicate SAs is reduced. The other benefit of this feature is to allow controlled support for negotiating connections in one direction only in a load-balancing scenario. It is not recommended that the servers or hubs initiate VPN connections toward the clients or spokes because these devices are all being accessed by a single-facing IP address as advertised via the load balancer. If the hubs were to initiate the connection, they would be doing so using an individual IP address, thus circumventing the benefits of the load balancer. The same is true of rekeying requests being sourced from the hubs or servers behind the load balancer. This feature is particularly relevant in static virtual interfaces where events such as routing protocol convergence can generate simultaneous tunnel negotiations. How to Configure IKE Responder-Only ModeConfiguring a Device As IKE Responder-Only
SUMMARY STEPS
DETAILED STEPS Additional ReferencesMIBsTechnical Assistance
Feature Information for IKE Responder-Only ModeThe following table provides release information about the feature or features described in this module. This table lists only the software release that introduced support for a given feature in a given software release train. Unless noted otherwise, subsequent releases of that software release train also support that feature. Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1005R) Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental. |
|||||||||||