Table Of Contents

Command Summary for Gigabit Ethernet SPAs

Command Summary for Gigabit Ethernet SPAs

---

Table 14-1 provides an alphabetical list of some of the most significant commands that are needed to configure, monitor, and maintain Gigabit Ethernet SPAs. For more information about the commands, see the Cisco IOS CMTS Cable Command Reference at the following URL:
http://www.cisco.com/en/US/docs/ios/cable/command/reference/cbl_book.html

Table 14-1 Command Summary 

Command	Purpose
Router(config-if)# card slot 4jacket-1	Preprovisions a line card slot in the Cisco uBR10012 router to accept a SIP-600.
Router# debug hw-module subslot	Debugs a SPA and all of its interfaces.
Router(config-if)# flowcontrol receive off	Disables flow control on the 1-Port 10-Gigabit Ethernet SPA.
Router(config-if)# hold-queue length in	Configures the input hold queue in units of packets.
Router(config)# interface gigabitethernet slot/subslot/port	Specifies the Gigabit Ethernet interface to configure.
Router(config-if)# ip address ip-address mask or Router(config-if)# ipv6 address ipv6-prefix/prefix-length	Sets a primary or secondary IP address for an interface.
Router(config-if)# ip accounting mac-address [input | output]	Generates accounting information for IP traffic based on the source and destination MAC addresses on LAN interfaces.
Router(config-if)# mac-address ieee-address	Modifies the default MAC address of an interface to a user-defined address.
Router(config-if)# mtu value	Sets the maximum transmission unit (MTU) value for the interface.
Router(config-if)# negotiation auto	Enables advertisement of speed, duplex mode, and flow control on a Gigabit Ethernet interface.
Router(config-if)# no shutdown	Enables an interface.
Router(config-if)# plim qos input map	Classifies ingress packets into priority and nonpriority queues on Gigabit Ethernet SPAs.
Router# show controllers interface slot/subslot/port [detail]	Displays initialization block information, transmit ring, receive ring, transmission statistics and errors, and applicable MAC destination address and VLAN filtering tables for Gigabit Ethernet SPA interface controllers.
Router# show hw-module subslot [all | slot/subslot] [fpd | oir | sensors | transceiver port-number]	Displays diagnostic information about internal hardware devices for all SPAs or a specific SPA.
Router# show interfaces	Displays the configured interface and checks the status of each interface port.
Router#  show running-config	Displays the router's running configuration and interfaces available in the system.
Router# show version	Displays the current software version, and can also be used to confirm that the router recognizes the line card.