Application Control Engine Module System Message Guide (Software Version A1(2))
Messages Listed by Severity Level
Download this chapter
Messages Listed by Severity LevelMessages Listed by Severity Level
Download the complete book
Cisco Application Control Engine Module System Message Guide Book-Length PDF (Software Version 3.0(0)A1(2))Cisco Application Control Engine Module System Message Guide Book-Length PDF (Software Version 3.0(0)A1(2)) (PDF - 2 MB)
give_us_feedback

Table Of Contents

Messages Listed by Severity Level

Alert Messages, Severity Level 1

Critical Messages, Severity Level 2

Error Messages, Severity Level 3

Warning Messages, Severity Level 4

Notification Messages, Severity Level 5

Informational Messages, Severity Level 6

Debugging Messages, Severity Level 7


Messages Listed by Severity Level

This appendix contains the following sections:

•Alert Messages, Severity Level 1

•Critical Messages, Severity Level 2

•Error Messages, Severity Level 3

•Warning Messages, Severity Level 4

•Notification Messages, Severity Level 5

•Informational Messages, Severity Level 6

•Debugging Messages, Severity Level 7

Note The ACE does not send severity 0, emergency messages to syslog. These are comparable to a UNIX panic message and indicate an unstable system.

Alert Messages, Severity Level 1

The following messages appear at severity level 1, alerts:

•%ACE-1-106021: Deny protocol reverse path check from source_address to dest_address on interface interface_name

•%ACE-1-106028: WARNING: Access rule memory exhausted while processing Access-group. Incomplete rules are currently applied on interface interface-name. Manual roll back to a previous access rule configuration on this interface is needed.

•%ACE-1-727001: hostname: HA: Peer IP address is not reachable. Error: error str.

•%ACE-1-727002: hostname: HA: FT interface interface name to reach peer IP address is down. Error: error str

•%ACE-1-727003: hostname: HA: Mismatch in context names detected for FT group FTgroupID. Cannot be redundant.

•%ACE-1-727004: hostname: HA: Two actives have been detected for FT group FTgroupID.

•%ACE-1-727005: hostname: HA: Config replication failed for context ctx name. Error : error str

•%ACE-1-727006: hostname: HA: Peer is incompatible due to error str. Cannot be Redundant.

•%ACE-1-727007: hostname: HA: Module Initialization failure - Error Error str.

•%ACE-1-727008: hostname: HA: Failed to send heartbeats to peer. Internal error: Error str

•ACE-1-728001: Initialization failure (general) type variable1

•ACE-1-728002: Initialization failure (sticky) type variable1

•ACE-1-728003: Initialization failure (sticky hash) variable1 entries, variable2 min, variable3 max type variable4

Critical Messages, Severity Level 2

The following messages appear at severity level 2, critical:

•%ACE-2-212007: SNMPD initialization failed while Variable1

•%ACE-2-313006: ICMP Manager Initialization Failed. Reason : Variable1

•%ACE-2-727009: hostname: HA: Communication failure for Peer Peer id Event: error str

•%ACE-2-727010: hostname: HA: Data replication failed for context ctx name. Error code error str

•%ACE-2-727011: HA: Configuration replication for context ctx name will not happen. Error: Error str

•%ACE-2-727012: hostname: HA: FT Group group ID changed state to NewState. Reason: reason str.

•%ACE-2-727013: hostname: HA: Peer Peer # is UP and reachable.

•%ACE-2-727014: hostname: HA: Heartbeats from Peer Peer id have become unidirectional.

•%ACE-2-727015: hostname: HA: Detected mismatch in heartbeat interval from Peer peer id. Modified interval to interval.

•%ACE-2-727016: hostname: HA: Replication for context ctx name has started. Status - status.

•%ACE-2-727017: hostname: HA: FT Track track type track name is UP.

•%ACE-2-727018: hostname: HA: FT Track track type track name is DOWN.

Error Messages, Severity Level 3

The following messages appear at severity level 3, errors:

•%ACE-3-212008: Failed while allocating memory in snmpd

•%ACE-3-251001: Probe configuration error, memory allocation failure.

•%ACE-3-251003: Could not load script script-name - File not found

•%ACE-3-251004: Could not load script script-name - memory allocation failure

•%ACE-3-251006: Health probe failed for server A.B.C.D on port P, internal error: error message

•%ACE-3-251007: ICMP health probe failed for server A.B.C.D, internal error: error message

•%ACE-3-251008: Health probe failed for server A.B.C.D on port P, connectivity error: server open timeout (no SYN ACK)

•%ACE-3-251009: ICMP health probe failed for server A.B.C.D, connectivity error: error message

•%ACE-3-251010: Health probe failed for server A.B.C.D on port P, error message

•%ACE-3-251011: ICMP health probe failed for server A.B.C.D, error message.

•%ACE-3-251012: Could not load script script-name - Error reading script-file

•%ACE-3-251013: Could not load script script-name - Error getting file size

•%ACE-3-313007: ICMP Manager Memory Problem. Reason: Variable1

•%ACE-3-322001: Deny MAC address MAC_address, possible spoof attempt on interface interface

•%ACE-3-322002: ARP inspection check failed for arp {request|response} received from host MAC_address on interface interface. This host is advertising MAC Address MAC_address_1 for IP Address IP_address, which is {statically|dynamically} bound to MAC Address MAC_address_2.

•%ACE-3-322003: ARP inspection check failed for arp {request|response} received from host MAC_address on interface interface. This host is advertising MAC Address MAC_address_1 for IP Address IP_address, which is not bound to any MAC Address.

•%ACE-3-327001: Detected Encap table Full when allocating encap entry for IP interface interface_name

•%ACE-3-440002: Addition failed for variable 1

•%ACE-3-440003: Deletion failed for variable 2

•%ACE-3-728005: Failed to transmit variable1 decision for connection from client variable2 type variable3

•%ACE-3-728007: Internal configuration communications error (sticky) type variable1

•%ACE-3-728008: Internal communications error (sticky) /source processor variable1 destination processor variable2 -- type variable3

•%ACE-3-728009: Context ID variable1 requested variable2 of variable3 sticky entries. No action taken. -- type variable4

•%ACE-3-728014: Internal cross-processor communications error (sticky) type variable1

•%ACE-3-728015: Internal channel communications error (sticky) type variable1

•%ACE-3-728017: Internal communications error (ha) -- type variable1

•%ACE-3-978031: Memory mapping for debug logging failed.

Warning Messages, Severity Level 4

The following messages appear at severity level 4, warning:

•%ACE-4-251002: The configured health probe script script-name for server A.B.C.D on port P is empty

•%ACE-4-251005: Could not unload script script-name

•%ACE-4-313004: Denied ICMP type=icmp_type, from source_address on interface interface_name to dest_address:no matching session

•%ACE-4-400000: IDS:1000 IP Option Bad Option List from IP_address to IP_address on interface interface_name

•%ACE-4-405001: Received ARP {request | response} collision from IP_address/mac_address on interface interface_name

•%ACE-4-410001: Dropped UDP DNS packet_type from source_interface:source_address/source_port to dest_interface:dest_address/dest_port; error_length_type length length bytes exceeds max_length_type limit of maximum_length bytes.

•%ACE-4-411001: Line protocol on interface interface_name changed state to up

•%ACE-4-411002: Line protocol on interface interface_name changed state to down

•%ACE-4-411003: Configuration status on interface interface_name changed state to up

•%ACE-4-411004: Configuration status on interface interface_name changed state to down

•%ACE-4-412001: MAC MAC_address moved from interface_1 to interface_2

•%ACE-4-442001: Health probe probe name detected real_server_name (interface interface_name) in serverfarm sfarm_name changed state to UP

•%ACE-4-442002: Health probe probe name detected real_server_name (interface interface_name) in serverfarm sfarm_name changed state to DOWN

•%ACE-4-728011: Context ID variable1 being variable2 should not have variable3 associated sticky groups -- type variable4

•%ACE-4-728013: A cache alignment error variable1 was detected during initialization -- type variable2

•%ACE-4-728016: HA data receive failure (type variable1)

•%ACE-4-728019: Sticky resources were not variable1 for this context -- type variable2

•%ACE-4-728024: Received an unknown variable1 type message (variable2) for Sticky from remote IXP variable3!

•%ACE-4-728027: Received unhandled message of type variable1 from CP SrcSAP variable2.

•%ACE-LB_General-4-728032: Real Server variable1 in Serverfarm variable2 has reached configured threshold for HTTP retcode variable3

Notification Messages, Severity Level 5

The following messages appear at severity level 5, notifications:

•%ACE-5-111008: User user executed the command string

•%ACE-5-111008: User user executed the command string

•%ACE-7-111009: User user executed cmd:string

•%ACE-5-199006 : Orderly reload started at when by whom. Reload reason: reason

•%ACE-5-304001: user source_address Accessed {URL} dest_address: url.

•%ACE-5-442003: Real Server real_server_name in serverfarm sfarm_name changed state to new state

•%ACE-5-504001: Security context context-name was added to the system

•%ACE-5-504002: Security context context-name was successfully removed from the system

•%ACE-5-727019: hostname: HA: Started alternate ping to IP address ip addr

•%ACE-5-727020: hostname: HA: Stopped alternate ping to IP address ip addr.

•%ACE-5-727021: hostname: HA: Peer is compatible.

•%ACE-5-727022: hostname: HA: Started sending heartbeats to peer Peer id interval value and count cnt

•%ACE-5-727023: hostname: HA: Stopped sending heartbeats to peer Peer id.

•%ACE-5-728004: Internal communications notice (general) type variable1

•%ACE-5-728006: Internal communications error (messaging) msg subType variable1 -- type variable2

•%ACE-5-728012: Context ID variable1 failed to receive return data -- type variable2

•%ACE-5-728018: Proxy connection variable1 rebalanced to server variable2

•%ACE-5-728028: Sticky mapping failed: variable1 variable2

Informational Messages, Severity Level 6

The following messages appear at severity level 6, informational:

•%ACE-6-302022: Built TCP connection id for interface:real-address/real-port (mapped-address/mapped-port) to interface:real-address/real-port (mapped-address/mapped-port)

•%ACE-6-302023: Teardown TCP connection id for interface:real-address/real-port to interface:real-address/real-port duration hh:mm:ss bytes bytes [reason]

•%ACE-6-302024: Built UDP connection id for interface:real-address/real-port (mapped-address/mapped-port) to interface:real-address/real-port (mapped-address/mapped-port)

•%ACE-6-302025: Teardown UDP connection id for interface:real-address/real-port to interface:real-address/real-port duration hh:mm:ss bytes bytes

•%ACE-6-302026: Built ICMP connection for faddr/NATed_ID gaddr/icmp_type laddr/icmpID

•%ACE-6-302027: Teardown ICMP connection for faddr/NATed ID gaddr/icmp_type laddr/icmpID

•%ACE-6-302028: Built TCP connection id for interface: real-address/real-port (mapped-address/mapped-port) to interface: real-address/real-port (mapped-address/mapped-port)

•%ACE-6-302029: Teardown TCP connection id for interface: real-address/real-port to interface: real-address/real-port duration hh:mm:ss bytes bytes [reason]

•%ACE-6-302030: Built UDP connection id for interface: real-address/real-port (mapped-address/mapped-port) to interface: real-address/real-port (mapped-address/mapped-port)

•%ACE-6-302031: Teardown UDP connection id for interface: real-address/real-port to interface: real-address/real-port duration hh:mm:ss bytes bytes

•%ACE-6-615003: VLAN VLAN-number not available for configuring an interface

•%ACE-6-615004: VLAN VLAN-number available for configuring an interface

•%ACE-6-728020: LB is configured to consume variable1 bytes of memory.

•%ACE-6-728021: Found inconsistent sticky entry. Terminating variable1.

•%ACE-6-728022: Invalid hash table index (variable1) used for variable2

•%ACE-6-728023: variable1 variable2 sticky entries from ContextId variable3.

•%ACE-6-728025: Dropped variable1 'variable2' messages (variable3 total) from IXP variable4 to IXP variable5!

•%ACE-6-728026: Attempting to use invalid lookup key for variable1 processing.

•%ACE-6-728029: HA state for FtGroup variable1 changed from variable2 to variable3 State variable4.

•%ACE-6-728030: Silently discarding HA data: variable1

Debugging Messages, Severity Level 7

•%ACE-7-111009: User user executed cmd:string