Table Of Contents

Failure Recovery

How to Configure the Failure Recovery Mode

Options

Configure the Failure Recovery Mode: Examples

Example 1

Example 2

Failure Recovery

---

This module describes how to configure failure recovery.

How to Configure the Failure Recovery Mode

The failure-recovery operation-mode command defines the behavior of the system after boot resulting from failure.

•Options 

•Configure the Failure Recovery Mode: Examples 

Options

The following options are available:

•operational —After failure, the system will return to operational mode.

•non-operational —After failure, the system will remain not operational.

The default value is operational .

---

Step 1 From the NME-APA(config)# prompt, type failure-recovery operation-mode operational|non-operational and press Enter.

Specify the desired failure recovery mode.

---

Configure the Failure Recovery Mode: Examples

Example 1

This example sets the system to boot as non-operational after a failure.

NME-APA(config)#failure-recovery operation-mode non-operational

Example 2

This example sets the system to the default failure recovery mode.

NME-APA(config)# default failure-recovery operation-mode