Table Of Contents

Technical Specifications

Monitoring Specifications

Electrical and Environmental Specifications

Physical Specifications

Regulatory Compliance

European Community Statement

FCC Class A Statement

VCCI (Japan)

BSMI (Taiwan)

Hungarian Class A Warning Notice

Technical Specifications

---

Monitoring Specifications

Environmental monitoring support	SAF-TE/SES
Automatic temperature sensing	Yes
Fan monitoring and control	Yes
Power supply monitoring	Yes
Disk drive monitoring	Yes
Insertion count monitoring	Yes
Failure notification	Audible alarm, LED

Electrical and Environmental Specifications

Operating temperature	10 to 35oC (50 to 95oF)
Operating humidity	8 to 80% (noncondensing)
Input rating AC (per power supply)	100-240 VAC, 5.0-2.1A, 50/60 Hz

Physical Specifications

	Maximum Number of Drives	Dimensions in cm (in.)	Weight in kg (lb)
Storage Array 12 (fully configured)	12	13.3 x 44.6 x 43.2 (5.25 x 17.55 x 17.0)	34.0 (75.0)

Regulatory Compliance

Compliance	CE1 Marking
Safety	UL2 1950, CSA3 -C22.2 No. 950, EN4 60950, IEC5 60950
EMC	FCC6 Part 15 (CFR 47) Class A, ICES7 003 Class A, EN 55022 Class A, CISPR228 Class A, AS/NZS9 3548 Class A, and VCCI10 Class A

1 CE = European Compliance. 2 UL = Underwriters Laboratories. 3 CSA = Canadian Standards Association. 4 EN = European Norm. 5 IEC = International Electrotechnical Commission. 6 FCC = Federal Communications Commission. 7 ICES = Interference-Causing Equipment Standard. 8 CISPR = International Special Committee On Radio Interference. 9 AS/NZS = Standards Australia/Standards New Zealand. 10 VCCI = Voluntary Control Council for Information Technology Equipment.

European Community Statement

This equipment complies with the following European directives:

EMC Directive 89/336/EEC and amending Directives 92/31/EEC and 93/68/EEC Low Voltage Directive 73/23/EEC.

FCC Class A Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference when operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference, in which case, the user will be required to correct the interference at his own expense.

Any changes or modifications to this equipment not expressly approved by Cisco Systems could void the user's authority to operate this equipment.

VCCI (Japan)

English Translation:

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment. If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

BSMI (Taiwan)

English Translation:

This is a Class A product. In a domestic environment this product may cause radio interference, in which case the user may be required to take adequate measures.

Hungarian Class A Warning Notice

Figyelmeztetés a felhasználói kézikönyv számára:

Ez a berendezés "A" osztályú termék, felhasználására és üzembe helyezésére a magyar EMC "A" osztályú követelményeknek (MSZ EN 55022) megfeleloen kerülhet sor, illetve ezen "A" osztályú berendezések csak megfelelo kereskedelmi forrásból származhatnak, amelyek biztosítják a megfelelo speciális üzembe helyezési körülményeket és biztonságos üzemelési távolságok alkalmazását.

English Translation:

This equipment is a Class A product and should be used and installed properly according to the Hungarian EMC Class A requirements (MSZ EN 55022). The Class A equipment is derived for typical commercial establishments for which special conditions of installation and protection distance are used.