Table Of Contents

DQL Configuration Mode Commands

(config-dql) description

(config-dql) domain

(config-dql) no

DQL Configuration Mode Commands

DQL configuration mode allows you to configure a Domain Qualifier List (DQL). A DQL is a collection of domain names which you can assign to a content rule, instead of creating a rule for each domain.

---

Note You cannot use wildcards in DQL entries.

---

To access DQL configuration mode, use the dql command from any configuration mode except boot, group, header-field-group, RMON alarm, RMON event, and RMON history configuration modes. The prompt changes to (config-dql [name]). You can also use this command from DQL mode to access another DQL. For information about commands available in this mode, refer to the following commands.

In global configuration mode, use the no form of this command to remove an existing DQL.

dql dql_name
(config) no dql existing_dql_name

Syntax Description

dql_name

The name of a new DQL you want to create or of an existing list. Enter an unquoted text string with no spaces and a maximum length of 31 characters. To see a list of existing DQL names, enter: dql ?

Related Commands

show dql
(config-owner-content) url

(config-dql) description

To provide a description for the domain qualifier list (DQL), use the description command.

description "text"

Syntax Description

text	The DQL description. Enter a quoted text string with a maximum length of 63 characters including spaces.

(config-dql) domain

To add a domain to the list of domains supported by this DQL, use the domain command. Use the no form of this command to remove a domain from this DQL.

domain name index number {"description"}
no domain name

Syntax Description

name	The name of the domain. Enter an unquoted text string with a maximum length of 63 characters (for example, www.point.com).
number	The index number for the domain. Enter a number from 1 to 10000. If a domain has more than one domain name, you can assign the same index number to its different names.
description	A description for the domain. Enter a quoted text string with a maximum length of 63 characters.

(config-dql) no

To negate a command or set it to its default, use the no command. For information on general no commands you can use in this mode, refer to the general no command. The following options are available in DQL mode.

Syntax Description

no acl index	Deletes an ACL
no domain name	Removes the specified domain from the DQL
no keepalive existing_keepalive_name	Deletes an existing keepalive
no nql existing_nql_name	Deletes an existing Network Qualifier List
no owner existing_owner_name	Deletes an existing owner
no rmon-event index	Deletes an RMON event
no rmon-history index	Deletes an RMON history