Guest

Cisco Aironet 1500 Series

Cisco Aironet 1500 Series Access Point Power Injector Installation Instructions

  • Viewing Options

  • PDF (174.5 KB)
  • Feedback
Cisco Aironet 1500 Series Access Point Power Injector Installation Instructions

Table Of Contents

Cisco Aironet 1500 Series Access Point Power Injector Installation Instructions

Technical Specifications

Safety Precautions

Installation Instructions


Cisco Aironet 1500 Series Access Point Power Injector Installation Instructions


The Cisco Aironet 1500 Series Access Point Power Injector products increase wireless LAN deployment flexibility of the access point by combining 48-VDC power with the data signal, sending both to the Cisco Aironet Access Point.


Note This device is not IEEE 802.3af compliant.


Technical Specifications

Input voltage

90 to 264 VAC

Input frequency

50 to 60 Hz

Output voltage

48 VDC

Maximum load

1.2 A

Short circuit protection

Auto recovery

Over voltage protection

Auto recovery

Operating temperature

0°F to 104°F
(-17°C to 40°C)

Storage temperature

-4°F to 185°F
(-20°C to 85°C)

Operating humidity

5% to 95%

Length

5.91 in. (15.01 cm)

Width

2.76 in. (7.01 cm)

Height

1.38 in. (3.50 cm)


Safety Precautions


Warning Only trained and qualified personnel should be allowed to install, replace, and service this equipment.


Installation Instructions

Follow these steps to install the power injector:


Step 1 Plug a Category-5 Ethernet cable into the port labeled Output on the power injector.


Note The maximum Ethernet cable length is 128 ft. (38 m) from the switch to the power injector and 200 ft. (61 m) from the power injector to the access point.


Step 2 Plug the other end of the Ethernet cable into the Ethernet Port on the access point.

Step 3 Plug a Category-5 Ethernet cable into the port labeled Input on the power injector.

Step 4 Plug the other end of the Ethernet cable into your 10/100 Ethernet switch, hub, or network.

Step 5 Plug the power cord into the three-pronged receptacle on the end of the Power Injector

Step 6 Connect the other end of the power cord into a 120-VAC to 250-VAC power source.