Running Mobility Ping Tests
Information About Mobility Ping Tests
Controllers in a mobility list communicate with each other by controlling information over a well-known UDP port and exchanging data traffic through an Ethernet-over-IP (EoIP) tunnel. Because UDP and EoIP are not reliable transport mechanisms, there is no guarantee that a mobility control packet or data packet will be delivered to a mobility peer. Mobility packets may be lost in transit due to a firewall filtering the UDP port or EoIP packets or due to routing issues.
Guidelines and Limitations
Controller software release 4.0 or later releases enable you to test the mobility communication environment by performing mobility ping tests. These tests may be used to validate connectivity between members of a mobility group (including guest controllers). Two ping tests are available:
- Mobility ping over UDP—This test runs over mobility UDP port 16666. It tests whether the mobility control packet can be reached over the management interface.
- Mobility ping over EoIP—This test runs over EoIP. It tests the mobility data traffic over the management interface.
Running Mobility Ping Tests (CLI)
- To test the mobility UDP control packet communication between two controllers, enter this command: mping mobility_peer_IP_address The mobility_peer_IP_address parameter must be the IP address of a controller that belongs to the mobility list.
- To test the mobility EoIP data packet communication between two controllers, enter this command: eping mobility_peer_IP_address The mobility_peer_IP_address parameter must be the IP address of a controller that belongs to the mobility list.
- To troubleshoot your controller for mobility ping, enter these commands: config logging buffered debugging show logging To troubleshoot your controller for mobility ping over UDP, enter this command to display the mobility control packet: debug mobility handoff enable