Cisco Wireless LAN Controller Configuration Guide, Release 7.4
Configuring Access Points with Dual-Band Radios
Downloads: This chapterpdf (PDF - 1.15MB) The complete bookPDF (PDF - 17.75MB) | The complete bookePub (ePub - 4.37MB) | Feedback

Configuring Access Points with Dual-Band Radios

Configuring Access Points with Dual-Band Radios

Configuring Access Points with Dual-Band Radios (GUI)


    Step 1   Choose Wireless > Access Points > Radios > Dual-Band Radios to open the Dual-Band Radios page.
    Step 2   Hover your cursor over the blue drop-down arrow of the AP and click Configure.
    Step 3   Configure the Admin Status.
    Step 4   Configure CleanAir Admin Status as one of the following:
    • Enable
    • Disable
    • 5 GHz Only
    • 2.4 GHz Only
    Step 5   Click Apply.
    Step 6   Click Save Configuration.

    What to Do Next

    You can monitor the access points with dual-band radios by navigating to Monitor > Access Points > Radios > Dual-Band Radios.

    Configuring Access Points with Dual-Band Radios (CLI)

    • Configure an access point with dual-band radios by entering this command:

      config 802.11-abgn {enable | disable} ap-name

    • Configure the CleanAir features for an access point with dual-band radios by entering this command:

      config 802.11-abgn cleanair {enable | disable} ap-name band 2.4-or-5-GHz