EU Directives 1999/5/EC & 93/42/ECC — Compliance Information for the Cisco Aironet 1600 series IEEE802.11 a/b/g/n Wireless LAN Products
This document contains compliance information for the Cisco AIR-CAP1600 Series Access Points that is relevant to the European Union and other countries that have implemented the EU Directive 1999/5/EC and/or EU Directive 93/42/EC.
The information in this document is applicable to the Cisco Aironet 1600 series wireless LAN products that currently include the following products:
2.4 & 5 GHz:
The equipment operates in the 2400- to 2483.5-MHz frequency range and in the 5150- to 5350-MHz and 5470- to 5725-MHz frequency range.
National regulations may require that operations be limited to portions of the frequency ranges identified above and/or at reduced power levels. See the National Restrictions for complete details.
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
This declaration is only valid for configurations (combinations of software, firmware and hardware) provided and/or supported by Cisco Systems for use within the EU. The use of software or firmware not supported/provided by Cisco Systems may result that the equipment is no longer compliant with the regulatory requirements.
Note The full declaration of conformity for this product can be found in the Declarations of Conformity and Regulatory Information section of the appropriate product hardware installation guide, which is available on Cisco.com. See the “Obtaining Documentation and Submitting a Service Request” section for instructions for downloading these documents.
The following standards were applied during the assessment of the product against the requirements of the Directive 1999/5/EC:
Radio: EN 301 893 and EN 300 328
EMC: EN 301 489-1 and EN 301 489-17
Safety: EN 60950-1 and EN 50385
This device also conforms to the EMC requirements of the Medical Directive 93/42/EEC and as contained in EN 60601-1-2: 2001.
For the Cisco AIR-CAP1600 Series Access Points, the following CE mark and Class-2 identifier are affixed to the equipment and its packaging:
Within the EU as well as within the majority of the other European Countries, the 2.4- and 5-GHz bands have been made available for the use of wireless LANs. Table 1 provides an overview of the regulatory requirements in general applicable for the 2.4- and 5-GHz bands.
Later in this section you will find an overview of countries in which additional restrictions or requirements or both are applicable.
The requirements for any country may evolve. Cisco recommends that you check with the local authorities for the latest status of their national regulations for both the 2.4- and 5-GHz wireless LANs.
Table 1 Overview of Regulatory Requirements for Wireless LANs
The following sections identify countries having additional requirements or restrictions than those listed in Table 1.
In Denmark, the band 5150 - 5350 MHz is also allowed for outdoor usage.
I Danmark må frekvensbåndet 5150 - 5350 også anvendes udendørs.
For 2.4 GHz, the output power is restricted to 10 mW EIRP when the product is used outdoors in the band 2454 - 2483.5 MHz. There are no restrictions when used indoors or in other parts of the 2.4 GHz band. Check http://www.arcep.fr/ for more details.
Pour la bande 2.4 GHz, la puissance est limitée à 10 mW en p.i.r.e. pour les équipements utilisés en extérieur dans la bande 2454 - 2483.5 MHz. Il n'y a pas de restrictions pour des utilisations en intérieur ou dans d'autres parties de la bande 2.4 GHz. Consultez http://www.arcep.fr/ pour de plus amples détails.
This product meets the National Radio Interface and the requirements specified in the National Frequency Allocation Table for Italy. Unless this wireless LAN product is operating within the boundaries of the owner's property, its use requires a “general authorization.” Please check http://www.sviluppoeconomico.gov.it/ for more details.
Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e rispetta il Piano Nazionale di ripartizione delle frequenze in Italia. Se non viene installato all 'interno del proprio fondo, l'utilizzo di prodotti Wireless LAN richiede una “Autorizzazione Generale”. Consultare http://www.sviluppoeconomico.gov.it/ per maggiori dettagli.
The outdoor usage of the 2.4 GHz band requires an authorization from the Electronic Communications Office. Please check http://www.esd.lv for more details.
2.4 GHz frekvenèu joslas izmantoðanai ârpus telpâm nepiecieðama atïauja no Elektronisko sakaru direkcijas. Vairâk informâcijas: http://www.esd.lv.
Note Although Norway, Switzerland and Liechtenstein are not EU member states, the EU Directive 1999/5/EC has also been implemented in those countries.
The AIR-CAP1602I-E-K9 has integrated antennas which cannot be removed or are user accessible.
The AIR-CAP1602E-E-K9 is equipped with antenna connectors for the use of (external) dedicated antennas. See Table 2 for the applicable maximum conducted power settings for each of the antennas.
Table 2 Dedicated (external) Dual Band Antennas & Maximum Allowed Conducted Power Settings
2.Outdoor operation is not allowed within 5150 - 5350 MHz.
The operating frequency in a Wireless LAN is determined by the access point. As such, it is important that the access point is correctly configured to meet the local regulations. See the “National Restrictions” section for the country specific operating frequency ranges.
These documents provide information about the controllers and access points:
Cisco WLAN Controller Configuration Guide
Quick Start Guide: Cisco Aironet 1600 Series Access Point
Note If you still have questions regarding the compliance of these products or you can not find the information you are looking for, please send an email request to Cisco at firstname.lastname@example.org
Obtaining Documentation and Submitting a Service Request
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)