Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide, OL-5048-06
Declarations of Conformity and Regulatory Information
Downloads: This chapterpdf (PDF - 1.2MB) The complete bookPDF (PDF - 2.44MB) | Feedback

Declarations of Conformity and Regulatory Information

Table Of Contents

Declarations of Conformity and Regulatory Information

Manufacturers Federal Communication Commission Declaration of Conformity Statement

VCCI Statement for Japan

Industry Canada

Canadian Compliance Statement

European Community, Switzerland, Norway, Iceland, and Liechtenstein

Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC

Declaration of Conformity for RF Exposure

Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan

Japanese Translation

English Translation

Administrative Rules for Cisco Aironet Access Points and Bridges in Taiwan

All Access Points and Bridges

Chinese Translation

English Translation

Operation of Cisco Aironet Access Points in Brazil

Access Point Models

Regulatory Information

Portuguese Translation

English Translation

Declaration of Conformity Statements

Declaration of Conformity Statements for European Union Countries


Declarations of Conformity and Regulatory Information


This appendix provides declarations of conformity and regulatory information for the 1300 series
access point/bridge (model: AIR-BR1310G and AIR-LAP1310G).

This appendix contains the following sections:

Manufacturers Federal Communication Commission Declaration of Conformity Statement

VCCI Statement for Japan

Industry Canada

European Community, Switzerland, Norway, Iceland, and Liechtenstein

Declaration of Conformity for RF Exposure

Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan

Administrative Rules for Cisco Aironet Access Points and Bridges in Taiwan

Operation of Cisco Aironet Access Points in Brazil

Declaration of Conformity Statements

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Autonomous Access Point/Bridge Models:

AIR-BR1310G-A-K9-R or
AIR-BR1310G-A-K9

Lightweight Access Point Models:

AIR-LAP1310G-A-K9-R or
AIR-LAP1310G-A-K9

FCC Certification Number:

LDK102052P (AIR-MP21G-A-K9-B-P) or
LDK102052 (AIR-MP21G-A-K9-B)

Manufacturer:

Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.

Increase separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from which the receiver is connected.

Consult the dealer or an experienced radio/TV technician.


Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency. Any changes or modification to said product not expressly approved by Cisco could void the user's authority to operate this device.

VCCI Statement for Japan

Warning


This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.

 



Industry Canada

Canadian Compliance Statement

This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numerique de la classe B respecte les exigences du Reglement sur le material broilleur du Canada.

This device complies with Class B Limits of Industry Canada. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

The device is certified to the requirements of RSS-210 for 2.4-GHz spread spectrum devices. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. For further information, contact your local Industry Canada office.

European Community, Switzerland, Norway, Iceland, and Liechtenstein

Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC

This device complies with the EMC requirements (EN 60601-1-2) of the Medical Directive 93/42/EEC.

This equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

For the 1300 series access point/bridge, the following standards were applied:

Radio: EN 300.328-1, EN 300.328-2

EMC: EN 301 489-1, EN 301 489-17

Safety: EN 60950

The following CE mark is affixed to the 1300 series equipment:

The above CE mark is required as of April 8, 2000 but might change in the future.


Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain frequencies and/or may require a license for operation. For more details, contact Cisco Corporate Compliance.



Note Combinations of power levels and antennas resulting in a radiated power level of above 100 mW eirp are considered as not compliant with the above mentioned directive and are not allowed for use within the European community and countries that have adopted the European R&TTE directive 1999/5/EC and/or the CEPT recommendation Rec 70.03. For more details on legal combinations of power levels and antennas, contact Cisco Corporate Compliance.


Declaration of Conformity for RF Exposure

The radio module has been evaluated under FCC Bulletin OET 65C and found compliant to the requirements in CFR 47 Sections 2.1091, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices. The AIR-ANT3338 dish antenna should be installed more than 22 cm from your body or nearby persons. All other antennas should be installed more than 20 cm from your body or nearby persons.

Guidelines for Operating Cisco Aironet Access Points and Bridges in Japan

This section provides guidelines for avoiding interference when operating Cisco Aironet access points in Japan. These guidelines are provided in both Japanese and English.

Japanese Translation

English Translation

This equipment operates in the same frequency bandwidth as industrial, scientific, and medical devices such as microwave ovens and mobile object identification (RF-ID) systems (licensed premises radio stations and unlicensed specified low-power radio stations) used in factory production lines.

1. Before using this equipment, make sure that no premises radio stations or specified low-power radio stations of RF-ID are used in the vicinity.

2. If this equipment causes RF interference to a premises radio station of RF-ID, promptly change the frequency or stop using the device; contact the number below and ask for recommendations on avoiding radio interference, such as setting partitions.

3. If this equipment causes RF interference to a specified low-power radio station of RF-ID, contact the number below.

Contact Number: 03-5549-6500

Administrative Rules for Cisco Aironet Access Points and Bridges in Taiwan

This section provides administrative rules for operating Cisco Aironet access points in Taiwan. The rules are provided in both Chinese and English.

All Access Points and Bridges

Chinese Translation

English Translation

Administrative Rules for Low-power Radio-Frequency Devices

Article 14

For those low-power radio-frequency devices that have already received a type-approval, companies, business units or users should not change its frequencies, increase its power or change its original features and functions.

Article 17

The operation of the low-power radio-frequency devices is subject to the conditions that no harmful interference is caused to aviation safety and authorized radio station; and if interference is caused, the user must stop operating the device immediately and can't re-operate it until the harmful interference is clear.

The authorized radio station means a radio-communication service operating in accordance with the Communication Act.

The operation of the low-power radio-frequency devices is subject to the interference caused by the operation of an authorized radio station, by another intentional or unintentional radiator, by industrial, scientific and medical (ISM) equipment, or by an incidental radiator.

Operation of Cisco Aironet Access Points in Brazil

This section contains special information for operation of Cisco Aironet access points in Brazil.

Access Point Models

AIR-BR1310G-A-K9
AIR-BR1310G-A-K9-R

Regulatory Information

Figure 1-1 contains Brazil regulatory information for the AIR-AP1310G-A-K9 and the AIR-BR1310G-A-K9-R access points.

Figure 1-1 Brazil Regulatory Information

Portuguese Translation

Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.

English Translation

This equipment operates on a secondary basis and consequently must accept harmful interference, including interference from stations of the same kind. This equipment may not cause harmful interference to systems operating on a primary basis.

Declaration of Conformity Statements

All the Declaration of Conformity statements related to this product can be found at the following URL:

http://www.ciscofax.com

Declaration of Conformity Statements for European Union Countries

The Declaration of Conformity statement for the European Union countries is listed below: