Table Of Contents
Supported MIBs
MIB List
Using FTP to Access the MIB Files
Supported MIBs
This appendix lists the Simple Network Management Protocol (SNMP) Management Information Bases (MIBs) that the access point/bridge supports for this software release. The Cisco IOS SNMP agent supports both SNMPv1 and SNMPv2. This appendix contains these sections:
•
MIB List
•Using FTP to Access the MIB Files
MIB List
•BRIDGE-MIB
•CISCO-AAA-SERVER-MIB
•CISCO-CDP-MIB
•CISCO-CLASS-BASED-QOS-MIB
•CISCO-CONFIG-COPY-MIB
•CISCO-CONFIG-MAN-MIB
•CISCO-DOT11-ASSOCIATION-MIB
•CISCO-DOT11-IF-MIB
•CISCO-ENTITY-VENDORTYPE-OID-MIB
•CISCO-ENV-MON-MIB
•CISCO-FLASH-MIB
•CISCO-IETF-DOT11-QOS-MIB
•CISCO-IETF-DOT11-QOS-EXT-MIB
•CISCO-IMAGE-MIB
•CISCO-IP-PROTOCOL-FILTER-MIB
•CISCO-MEMORY-POOL-MIB
•CISCO-PROCESS-MIB
•CISCO-PRODUCTS-MIB
•CISCO-SMI
•CISCO-SYSLOG-MIB
•CISCO-SYSLOG-EVENT-EXT-MIB
•CISCO-TC
•CISCO-TBRIDGE-DEV-IF-MIB
•CISCO-WLAN-VLAN-MIB
•ENTITY-MIB
•IANAifType-MIB
•IEEE802dot11-MIB
•IF-MIB
•INET-ADDRESS-MIB
•OLD-CISCO-SYS-MIB
•OLD-CISCO-SYSTEM-MIB
•OLD-CISCO-TS-MIB
•P-BRIDGE-MIB
•Q-BRIDGE-MIB
•RFC1213-MIB
•RFC1398-MIB
•SNMPv2-MIB
•SNMPv2-SMI
•SNMPv2-TC
Using FTP to Access the MIB Files
Follow these steps to obtain each MIB file by using FTP:
Step 1 Use FTP to access the server ftp.cisco.com.
Step 2 Log in with the username anonymous.
Step 3 Enter your e-mail username when prompted for the password.
Step 4 At the ftp> prompt, change directories to /pub/mibs/v1 or /pub/mibs/v2.
Step 5 Use the get MIB_filename command to obtain a copy of the MIB file.
Note You can also access information about MIBs on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Feedback