Cisco IOS Software Configuration Guide for Cisco Aironet Access Points Cisco IOS Releases 12.4(10b)JA and 12.3(8)JEC
Appendix B - Supported MIBs
Downloads: This chapterpdf (PDF - 74.0KB) The complete bookPDF (PDF - 8.65MB) | Feedback

Supported MIBs

Table Of Contents

Supported MIBs

MIB List

Using FTP to Access the MIB Files


Supported MIBs


This appendix lists the Simple Network Management Protocol (SNMP) Management Information Bases (MIBs) that the access point supports for this software release. The Cisco IOS SNMP agent supports SNMPv1, SNMPv2, and SNMPv3. This appendix contains these sections:

MIB List

Using FTP to Access the MIB Files

MIB List

IEEE802dot11-MIB

Q-BRIDGE-MIB

CISCO-DOT11-LBS-MIB

CISCO-DOT11-IF-MIB

CISCO-WLAN-VLAN-MIB

CISCO-IETF-DOT11-QOS-MIB

CISCO-IETF-DOT11-QOS-EXT-MIB

CISCO-DOT11-ASSOCIATION-MIB

CISCO-L2-DEV-MONITORING-MIB

CISCO-IP-PROTOCOL-FILTER-MIB

CISCO-SYSLOG-EVENT-EXT-MIB

CISCO-TBRIDGE-DEV-IF-MIB

CISCO-TC-MIB

CISCO-SYSLOG-MIB

CISCO-WDS-INFO-MIB

Using FTP to Access the MIB Files

Follow these steps to obtain each MIB file by using FTP:


Step 1 Use FTP to access the server ftp.cisco.com.

Step 2 Log in with the username anonymous.

Step 3 Enter your e-mail username when prompted for the password.

Step 4 At the ftp> prompt, change directories to /pub/mibs/v1 or /pub/mibs/v2.

Step 5 Use the get MIB_filename command to obtain a copy of the MIB file.



Note You can also access information about MIBs on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml