Configuration Guide for Cisco Unified MeetingPlace Release 8.6
Configuring a Multinode System with Two EMS Nodes
Downloads: This chapterpdf (PDF - 71.0KB) The complete bookPDF (PDF - 7.28MB) | Feedback

Configuring a Multinode System with Two EMS Nodes

Table Of Contents

Configuring a Multinode System with Two EMS Nodes

Configuring Your Multinode System


Configuring a Multinode System with Two EMS Nodes


This module describes how to quickly configure a multinode system with two EMS nodes.

Configuring Your Multinode System

Configuring Your Multinode System

Procedure

 
High-Level Task
Where to Find Instructions

Step 1 

Install or upgrade your Cisco WebEx site to version WBS27 SP27 or later. Your Cisco WebEx Site must have XML API 5.8 enabled. This task requires approximately 24 to 48 hours.


Note If Cisco Unified MeetingPlace detects that your system does not meet the minimum requirements, a warning message in your administrative interface requests that you contact technical support.


Cisco WebEx Site Administration documentation

Step 2 

Obtain two physical or virtual servers to host Cisco Unified MeetingPlace.

"Installing the Cisco Unified MeetingPlace Web Server Software" module in the Installation, Upgrade, and Migration Guide for Cisco Unified MeetingPlace

Step 3 

Install Cisco Unified MeetingPlace on two application servers. During the installation process, select Express for your media server type and select MeetingPlace/WebEx with WebEx Scheduling as your deployment type. This task requires approximately one hour per installation.

"Installing the Cisco Unified MeetingPlace Web Server Software" module in the Installation, Upgrade, and Migration Guide for Cisco Unified MeetingPlace

Step 4 

Sign in to the Administration Center and use the Cisco WebEx Configuration page to connect your Cisco Unified MeetingPlace installation to your Cisco WebEx site. This task requires 5-10 minutes.

About Integrating with Cisco WebEx module

Step 5 

Choose one of your two application servers to be your master node and add your second server as a node to the first server's system. This task requires 5-10 minutes.

Configuring Nodes

Step 6 

Configure a test account in your Cisco WebEx interface and use the account to schedule and launch a Cisco WebEx meeting. This task requires approximately 15 minutes.

Cisco WebEx Site Administration documentation

Your installation and configuration tasks are complete and you have a functional multinode system.