Configuration Guide for Cisco Unified MeetingPlace Release 8.5
Configuring Direct Inward Dial
Downloads: This chapterpdf (PDF - 65.0KB) | Feedback

Configuring Direct Inward Dial on MeetingPlace-Scheduled and Audio-Only Deployments

Table Of Contents

Configuring Direct Inward Dial on MeetingPlace-Scheduled and Audio-Only Deployments


Configuring Direct Inward Dial on MeetingPlace-Scheduled and Audio-Only Deployments


Release 8.5
Revised: September 19, 2011 3:25 pm

The Direct Inward Dial (DID) feature enables users to call directly into a meeting by dialing the meeting ID, instead of dialing one of the Cisco Unified MeetingPlace access phone numbers on the Usage Configuration Page.

Before You Begin

Configure your call-control device to route DID calls to the Application Server.

For example, in Cisco Unified Communications Manager, configure a route pattern for each meeting ID that you want to make available for DID. Configure these route patterns to send calls to the trunk that leads to the Cisco Unified MeetingPlace Application Server. See the Configuring Call Control for Cisco Unified MeetingPlace module.

Restrictions

DID callers can join meetings as profiled users through the auto attend feature. If, however, the Auto attend mode user profile field is set to None, then the DID caller can join meetings only as a guest.

Procedure


Step 1 Sign in to the Administration Center.

Step 2 Select System Configuration > Usage Configuration.

Step 3 Set the Route calls to meeting ID that matches DID field to Yes.

Step 4 Select Save.


Related Topics

Field Reference: Usage Configuration Page in the Administration Center Page References for Cisco Unified MeetingPlace module

Configuring the Auto Attend Feature for Cisco Unified MeetingPlace on MeetingPlace-Scheduled and Audio-Only Deployments module