The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes common questions or situations relating to the function or performance of Cisco WebAttendant.
Contact your system administrator to verify and update the following information:
•The MAC address for the Cisco IP phone you are using in conjunction with Cisco WebAttendant
•The IP addresses or DNS names for the Cisco Telephony Call Dispatcher (TCD) and ports
•The Cisco WebAttendant User ID and password
The Cisco CallManager or the network connection failed, or the Cisco IP phone associated with Cisco WebAttendant registered with a different Cisco CallManager. You can wait a short time, then periodically try to log in to Cisco WebAttendant.
Contact your system administrator if the problem persists.
The Cisco CallManager failed or has not been started, or the network connection failed. Contact your system administrator.
A small blue phone (IP Telephone Console), a 3P (Third-Party Control), and a red LS (Line Status Client) designate icons associated with Cisco WebAttendant. When Cisco WebAttendant is running, these icons should display in your system tray.
The information in the User area of Cisco CallManager Administration directly determines the information in the directory. Contact your system administrator and request that the User area be updated with complete information for each person or directory number in the system.
The speed-dial button allows only six digits to display; therefore, the entire number may not show. You can use the Description (the area next to the button) field to display the entire number. See "Configuring Speed Dial Buttons" section for more information.
Currently, you can use only the default colors.
Ask your system administrator to verify that the "wauser" directory is set up properly. The system administrator should refer to the Cisco CallManager System Guide and to the Cisco CallManager Administration Guide for more information on how to accomplish this task.