Cisco Unified Serviceability Administration Guide, Release 7.0(1)
Configuring the SNMP System Group
Downloads: This chapterpdf (PDF - 346.0KB) The complete bookPDF (PDF - 5.01MB) | Feedback

Configuring SNMP System Group

Table Of Contents

Configuring SNMP System Group

Configuring the MIB2 System Group

MIB2 System Group Configuration Settings

Where to Find More Information


Configuring SNMP System Group


Cisco Unified Serviceability provides the MIB2 System Group Configuration window where you can configure the system contact and system location objects for the MIB-II system group. For example, you could enter Administrator, 555-121-6633, for the system contact and San Jose, Bldg 23, 2nd floor, for the system location. This chapter contains information on the following topics:

Configuring the MIB2 System Group

MIB2 System Group Configuration Settings

Where to Find More Information

Configuring the MIB2 System Group

Perform the following procedure to configure a system contact and system location for the MIB-II system group.


Tip This procedure supports SNMP v1, v2c, and v3 configuration.


Procedure


Step 1 Choose Snmp > SystemGroup > MIB2 System Group.

Step 2 Configure the settings, as described in Table 17-1.

Step 3 Click Save.

Step 4 A message indicates that changes will not take effect until you restart the SNMP master agent. To continue the configuration without restarting the SNMP master agent service, click Cancel. To restart the SNMP master agent service, click OK.


Note To clear the System Contact and System Location fields, click the Clear All button. To delete the system configuration, click the Clear All button and the Save button.



Additional Information

See the "Related Topics" section.

MIB2 System Group Configuration Settings

Table 17-1 describes the MIB2 System Group configuration settings. For related procedures, see the "Related Topics" section.

Table 17-1 MIB2 System Group Configuration Settings 

Field
Description

Server

From the drop-down list box, choose the server for which you want to configure contacts; then, click Go.

System Contact

In the field, enter a person to notify when problems occur.

System Location

In the field, enter the location of the person that is identified as the system contact.

Unified CM clusters only:

Apply To All Nodes

To apply the system configuration to all of the nodes in the cluster, check the check box.


Where to Find More Information

Related Topics

Understanding Simple Network Management Protocol, page 14-1

Configuring SNMP V1/V2c, page 15-1

Configuring SNMP V3, page 16-1