Cisco Unified CallManager Serviceability System Guide, Release 4.2(3)
Show Command Line Interface
Downloads: This chapterpdf (PDF - 182.0KB) The complete bookPDF (PDF - 5.76MB) | Feedback

Show Command Line Interface

Table Of Contents

Show Command Line Interface

Show Command Syntax

Where to Find More Information


Show Command Line Interface


This chapter provides an overview of the Cisco Show command (see Show Command Syntax).

A command line tool, show, displays the contents of the Cisco Unified CallManager configuration database, configuration file, memory statistics, and/or the Windows diagnostic information.

Show Command Syntax

You must install the Cisco Unified CallManager to use the show tool. Run the show command from a DOS shell. You can display the output data on the console or save it into a text file.


Note Because the show command uses a temporary file in the \Temp directory for the output, check to see that you have enough disk space available to receive it. The amount that you will need varies depending on a number of factors; for example, the number of users and devices being used and the size of the database being used by the system.


Alternatively, you can run show.exe from a Telnet session if Telnet server software is enabled.

The Program Files\Cisco\Bin directory contains the file show.exe.

The following syntax applies for the show command:

show [-f <filename>] [-c <column width>] [-w <console width>] [-v] [command]

Where to Find More Information

Related Topic

Chapter 30, "Show Command Line Interface," Cisco Unified CallManager Serviceability Administration Guide

Additional Cisco Documentation

Troubleshooting Guide for Cisco Unified CallManager