Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager Release 7.1(3)
New and Changed Information
Downloads: This chapterpdf (PDF - 123.0KB) The complete bookPDF (PDF - 10.49MB) | Feedback

New and Changed Information

Table Of Contents

New and Changed Information

Cisco Unified Communications Manager Release 7.1(3)

Features Supported in Previous Releases

Cisco Unified Communications Manager Release 7.1(2)

Cisco Unified Communications Manager Release 7.0(1)

Cisco Unified Communications Manager Release 6.1

Cisco Unified Communications Manager Release 6.0

Cisco Unified Communications Manager Release 5.1

Cisco Unified Communications Manager Release 5.0


New and Changed Information


This chapter describes new and changed JTAPI information for Cisco Unified Communications Manager, release 7.1(3) and features supported in the previous releases. It contains the following sections:

Cisco Unified Communications Manager Release 7.1(3)

Features Supported in Previous Releases

For more information, go to the Programming Guides website at http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_programming_reference_guides_list.html.

Cisco Unified Communications Manager Release 7.1(3)

This section describes the new and changed features in Cisco Unified Communications Manager Release 7.1(3):

Terminal and Address Capability Settings—This feature introduces interfaces that expose different configuration settings of address and terminal. These interfaces can be called even when the terminal or address is in out-of-service state. For more information, see Terminal and Address Capability Settings, page 3-112.

Features Supported in Previous Releases

This section describes the features supported in the releases prior to 7.1(2) and contains the following

sections:

Cisco Unified Communications Manager Release 7.1(2)

Cisco Unified Communications Manager Release 7.0(1)

Cisco Unified Communications Manager Release 6.1

Cisco Unified Communications Manager Release 6.0

Cisco Unified Communications Manager Release 5.1

Cisco Unified Communications Manager Release 5.0

Cisco Unified Communications Manager Release 7.1(2)

This section describes the new and changed features in Cisco Unified Communications Manager Release 7.1(2):

Drop Any Party, page 3-40.

IPv6 Support, page 3-50.

Direct Transfer Across Lines, page 3-32.

Join Across Lines or Connected Conference Across Lines, page 3-52.

Swap or Cancel and Transfer or Conference Behavior, page 3-111.

Message Waiting Indicator Enhancement, page 3-64.

Park Monitoring and Assisted DPark Support, page 3-69.

Logical Partitioning, page 3-61.

Component Updater, page 3-24.

Support for Cisco Unified IP Phone 6900 Series, page 3-110.

Cisco Unified Communications Manager Release 7.0(1)

This section describes the new and changed features in Cisco Unified Communications Manager from Release 6.1 to Release 7.0(1) and Cisco Unified JTAPI enhancements. It has the following sections:

Join Across Lines with Conference Enhancements, page 3-57

Locale Infrastructure Development, page 3-60

Do Not Disturb-Reject, page 3-39

Calling Party Normalization, page 3-10

Click to Conference, page 3-22

Extension Mobility Username Login, page 3-42

Java Socket Connect Timeout, page 3-51

selectRoute() with Calling Search Space and Feature Priority, page 3-98

Call Pickup, page 3-7


Note Cisco Unified Communications Manager Release 7.0(1) does not support the following IPv6 related methods:

canSupportIPv6()
setProviderOpenRetryAttempts (int retryAttempts)
getProviderOpenRetryAttempts()
getIPAddressingMode() (available on CiscoMediaTerminal and CiscoRouteTerminal interfaces)
register(java.net.InetAddress address, int port, CiscoMediaCapability [] capabilities, int[] algorithmIDs, java.net.InetAddress address_v6, int activeAddressingMode)
register(CiscoMediaCapability [] capabilities, int[] int registration Type, int[] algorithmIDs, int activeAddressingMode)
getTerminals() (available on new interface CiscoProviderTermCapabilityChangedEv)
getAddressingModeForMedia()
getCallingPartyIpAddr_v6() (available on CiscoCallCtlConnOfferedEv and CiscoRouteEvent interfaces)
CTIERR_IPADDRMODEMISMATCH
CTIERR_DYNREG_IPADDRMODE_MISMATCH
hasIPv6CapabilityChanged()
CiscoTerminal.IP_ADDRESSING_MODE_IPv4
CiscoTerminal.IP_ADDRESSING_MODE_IPv6
CiscoTerminal.IP_ADDRESSING_MODE_IPv4_v6
CiscoTerminal.IP_ADDRESSING_MODE_Unknown
CiscoTermRegistrationFailedEv.IP_ADDRESSING_MODE_MISMATCH



Note For the features, Join Across Lines, Do Not Disturb-Reject, and Calling Party Normalization, each JTAPI application must be upgraded to a version that is compatible with these features. Additionally, if you are upgrading from Release 5.1 and you use Join Across Lines, the Conference Chaining feature must not be enabled or used until all applications are either upgraded to a version compatible with the new CUCM version. Also, you should verify that the applications are not impacted by the Conference Chaining feature.


Cisco Unified Communications Manager Release 6.1

This section describes the new and changed features in Cisco Unified Communications Manager from Release 6.0 to Release 6.1 and Cisco Unified JTAPI enhancements. It has the following sections:

Certificate Download API Enhancement, page 3-11

Join Across Lines, page 3-51

Intercom Support for Extension Mobility, page 3-49

Cisco Unified Communications Manager Release 6.0

This section describes the new and changed features in Cisco Unified Communications Manager, Release 6.0 and Cisco Unified JTAPI enhancements. It has the following sections:

Recording and Silent Monitoring, page 3-80

Intercom, page 3-48

Arabic and Hebrew Language Support, page 3-1

Do Not Disturb, page 3-38

Secure Conferencing, page 3-89

Cisco Unified IP 7931G Phone Interaction, page 3-17

Version Format Change, page 3-130

Calling Party IP Address, page 3-9

Multilevel Precedence and Preemption Support, page 3-67

Noncontroller Adding of Parties to Conferences, page 3-69

Conference Chaining, page 3-28

Forwarding on No Bandwidth and Unregistered DN, page 3-44

Directed Call Park, page 3-37

Voice MailBox Support, page 3-131

Translation Pattern Support, page 3-121

CiscoRTPHandle Interface on Cisco RTP Events, page 3-19

Hold Reversion, page 3-47

Translation Pattern Support, page 3-121

Calling Party IP Address, page 3-9

Cisco Unified Communications Manager Release 5.1

This section describes the new and changed features in Cisco Unified Communications Manager, from Release 5.0 to Release 5.1 and Cisco Unified JTAPI enhancements. It has the following sections:

Join Across Lines, page 3-52

New Error Code in CiscoTermRegistrationFailedEv, page 3-68

Star (*) 50 Update, page 3-107

Call Forward Override, page 3-7

Cisco Unified Communications Manager Release 5.0

This section describes the new and changed features in Cisco Unified Communications Manager, from Release 4.x to Release 5.0 and Cisco Unified JTAPI enhancements. It has the following:

Partition Support, page 3-71

Hairpin Support, page 3-46

QoS Support, page 3-77

Transport Layer Security (TLS), page 3-122

SIP Phone Support, page 3-103

Secure Real-Time Protocol Key Material, page 3-90

SIP REFER or REPLACE, page 3-106

SIP 3XX Redirection, page 3-102

Terminal and Address Restrictions, page 3-113

Unicode Support, page 3-128

Linux, Windows, and Solaris Installation, page 3-59

Silent Install, page 3-101

Command Line Invocation, page 3-24

JTAPI Client Installer, page 3-58

JRE 1.2 and JRE 1.3 Support Removal, page 3-58

Superprovider and Change Notification, page 3-108

Half-Duplex Media Support, page 3-46

Half-Duplex Media Support, page 3-46

Network Alerting, page 3-67

Auto Updater for Linux, page 3-2

Call Select Status, page 3-8

JTAPI Version Information, page 3-59