Cisco Unified Communications Manager Administration Guide, Release 8.0(2)
Enterprise Parameters Configuration
Downloads: This chapterpdf (PDF - 339.0KB) The complete bookPDF (PDF - 18.29MB) | Feedback

Enterprise Parameters Configuration

Table Of Contents

Enterprise Parameters Configuration

Updating Enterprise Parameters

Synchronizing Enterprise Parameters With Affected Devices


Enterprise Parameters Configuration


Enterprise parameters provide default settings that apply to all devices and services in the same cluster. (A cluster comprises a set of Cisco Unified Communications Managers that share the same database.) When you install a new Cisco Unified Communications Manager, it uses the enterprise parameters to set the initial values of its device defaults. For more information on device defaults, refer to the "Device Defaults Configuration" section on page 95-1 and refer to the "System-Level Configuration Settings" section of the Cisco Unified Communications Manager System Guide.

You cannot add or delete enterprise parameters, but you can use the following procedures to update existing enterprise parameters or synchronize enterprise-parameter configuration changes with affected devices. Refer to the following sections:

Updating Enterprise Parameters

Synchronizing Enterprise Parameters With Affected Devices


Note Many of the enterprise parameters rarely require change. Do not change an enterprise parameter unless you fully understand the feature that you are changing or unless the Cisco Technical Assistance Center (TAC) specifies the change.



Tip Clicking the Set to Default button updates all parameters to the suggested value, which is the default that displays on the right side of the parameter. If a parameter does not have a suggested value, Cisco Unified Communications Manager does not update the value when you click the Set to Default button; for example, the Phone URL Parameters in the Enterprise Parameters Configuration window do not display a suggested value, so clicking the Set to Default button does not change the value that you configured.


Updating Enterprise Parameters


Step 1 Choose System > Enterprise Parameters.

Step 2 Update the appropriate parameter settings.

To view the description of a particular enterprise parameter, click the parameter name. To view the descriptions of all the enterprise parameters, click the ? button.

Step 3 To save the changes in the database, click Save.


Synchronizing Enterprise Parameters With Affected Devices

To synchronize devices with Enterprise Parameters that have undergone configuration changes, perform the following procedure, which will apply any outstanding configuration settings in the least-intrusive manner possible. (For example, a reset/restart may not be required on some affected devices.)

Procedure


Step 1 Choose System > Enterprise Parameters.

The Enterprise Parameters Configuration window displays.

Step 2 Make any necessary configuration changes.

Step 3 Click Save.

Step 4 Click Apply Config.

The Apply Configuration Information dialog displays.

Step 5 Click OK.