Cisco CallManager Administration Guide, Release 3.0(5)
Server
Downloads: This chapterpdf (PDF - 117.0KB) The complete bookPDF (PDF - 4.81MB) | Feedback

Server

Table Of Contents

Server

Adding a Server

Updating a Server

Deleting a Server


Server


Use server configuration to specify the address of the server where Cisco CallManager is installed. If your network uses Domain Name System (DNS) services, you can specify the DNS name of the server. If your network does not use DNS services, you must specify the Internet Protocol (IP) address of the server.


Note You must update the DNS server with the appropriate Cisco CallManager name and address information before using that information to configure the Cisco CallManager server.


Use the following procedures to add, update, or delete a server address in the Cisco CallManager database:

Adding a Server

Updating a Server

Deleting a Server

Adding a Server

This section describes how to add a server address to the Cisco CallManager database.


Note Server information is configured automatically in the database when you install the Cisco CallManager software.


Procedure


Step 1 Open Cisco CallManager Administration.

Step 2 Select System > Server.

Step 3 If your network uses DNS services, you can enter the DNS name of the Cisco CallManager server. Otherwise, you must enter the full IP address of the server.


Note You must update the DNS server with the appropriate Cisco CallManager name and address information before using that information here.


Step 4 Optionally you can enter the Media Access Control (MAC) address of the Network Interface Card (NIC) in the Cisco CallManager server. The MAC address is the permanent hardware address of the NIC. If you plan to move the server periodically to different locations on the network, Cisco recommends that you enter the MAC address so that other devices on the network can always identify the server. If you do not plan to relocate the server, you can omit the MAC address.

Step 5 Click Insert to save the server information in the database.

After adding a server, you can configure other properties of the Cisco CallManager installed on that server.

Changes to the server configuration do not take effect until you restart Cisco CallManager.


Related Topics

Adding a Cisco CallManager, page 12-1

Starting and Stopping Cisco CallManager, page 20-1

Updating a Server

This section describes how to update server information in the Cisco CallManager database.

Procedure


Step 1 Open Cisco CallManager Administration.

Step 2 Select System > Server.

Step 3 From the server list, select the server you want to update.

Step 4 Make the desired changes in the fields you want to update. Before saving the changes, you can click Cancel to reset all fields to their original value.

Step 5 Click Update to save the changes in the database.

Changes to the server configuration do not take effect until you restart Cisco CallManager.


Related Topics

Starting and Stopping Cisco CallManager, page 20-1

Deleting a Server

This section describes how to delete a server from the Cisco CallManager database.

Before You Begin

You cannot delete a server that has a specific Cisco CallManager running on it. If you try to delete a server that is in use, Cisco CallManager displays an error message. Before deleting a server that is currently in use, you must perform either or both of the following tasks:

Update the Cisco CallManager in question and assign it to a different server. See the "Updating a Cisco CallManager" section on page 12-5.

Delete the Cisco CallManager assigned to the server you want to delete. See the "Deleting a Cisco CallManager" section on page 12-6.

Procedure


Step 1 Open Cisco CallManager Administration.

Step 2 Select System > Region.

Step 3 In the server list, select the server you want to delete.

Step 4 Click Delete.

If the server is not in use, it is deleted. If it is in use, an error message is displayed.

Changes to the server configuration do not take effect until you restart Cisco CallManager.


Related Topics

Starting and Stopping Cisco CallManager, page 20-1