Hello,I've tried on my own for too long to figure this out so looking for assistance please...My home network has FTTB providing 100 Mbps down and 40 Mbps up. Clients associated to the WAP371 (FW 1.3.0.7, the latest), however, get 0.5Mbps down and pi...
Does anyone have the firmware RV34X v1.0.03.18?I'm looking for this specific firmware version as our course requires us to reproduce a vulnerability. Unfortunately, the corresponding version is no longer available for download on the official website...
Hi team i want to check warranty of my Cisco device so we can extend warranty with you and i have check with your tool warranty finder. This tool not provide correct information. So, please provide right tool for me so we can check ;warranty stat...
Hello, I have an SF300 and I was browsing to find which type of cabling I would need to buy, I understand that it's a female db9, but I was curious if it was any or if it had to follow a specific type. As well as if there's any recommendations for wh...
Together with the Cisco Business 150AX, we introduced an extender.Using the Cisco Business Mobile application, after setting the AP of the CBW150AX, add the CBX151AXM by scanning the QR code in the same app, and turn on. (More than 10 minutes?) After...
1. DHCP is working and provides IP addresses for everything else connected2. the voice modem has been rebooted and reset both -- twice3. ***** 112# says the IP address is 0.0.0.04. I've tried reserving an address for the MAC address, no go either but...
Hello.SPA 112 didn't accept network parameters when used IVR for Administration.When I filled in parameters using IVR menu, then SPA 112 rebooted and not accepted setting.Maybe I must use some instructions, which were not wrote in administration guid...
I bought a Cisco VoIP lab that came with two 7945 phones. I then bought an additional lot of six more 7945 phones. The first two and four of the second six all work with no problems. However, two of the additional six fail when downloading the fir...
I have a network infrastructure consisting of a 9 Cisco SF300-24 managed switch and a 24 D-Link DAP2662 wireless access point, for the network. my computer is directly connected to the Switch and is able to acquire an IP address and establish interne...
Hi,I am trying to confiqure my SPA112 using the default ip address of 192.168.15.1 however it doesnt seem to point me to the admin panel.When I phone the IVR to check the IP address it gives me 0.0.0.0 and no matter how many times I try to change it ...
Thank you for any help.Brand New Small Business installing 150 AX. 3 total. Can location/radio interference cause an issue?I have one location that will not obtain IP address(red,green,off) I can change the units (use different Access Points), take...