Cisco Emergency Responder 8.6 Troubleshooting Guide
Starting and Stopping a Cisco Emergency Responder Server
Downloads: This chapterpdf (PDF - 340.0KB) The complete bookPDF (PDF - 1.24MB) | Feedback

Starting And Stopping A Cisco Emergency Responder Server

Table Of Contents

Starting And Stopping A Cisco Emergency Responder Server


Starting And Stopping A Cisco Emergency Responder Server


When you install Cisco Emergency Responder (Emergency Responder), the Emergency Responder server is set up to automatically start whenever the computer is powered up or rebooted. However, you can stop and then restart an Emergency Responder server through the Emergency Responder Serviceability web interface without powering down or rebooting the computer. You might find this helpful if you are trying to debug a problem.

To start or stop an Emergency Responder server, follow these steps:

Procedure


Step 1 Log in to the Emergency Responder Serviceability web interface and select Tools > Control Center.

The Control Center Services page displays, showing all Emergency Responder services and the current status of each one.

Step 2 Click the radio button to the left of the service name, then click Start, Stop, or Restart to perform the desired action on the service. Click Refresh to refresh the screen with updated information.


Note The buttons only appear if the action is possible; for example, Start only appears if the service is currently stopped.




Note The Cisco Tomcat and Cisco IDS services cannot be started or stopped from the Control Center. These services can only be started or stopped using the utils service command. For additional information, see the Cisco Emergency Responder 8.6 Administration Guide.


Table 10-1 explains the meaning of the icons you see on the Control Center Services page.

Table 10-1 Cisco Emergency Responder Control Center Icons

Icon
Meaning

The Emergency Responder server or the Emergency Responder Phone Tracking Engine is started and functioning normally.

The Emergency Responder server Emergency Responder Phone Tracking Engine was stopped by the administrator.


For additional information, see the Control Center section in the Cisco Emergency Responder 8.6 Administration Guide.