Cisco TelePresence System TX9000 and TX9200 Assembly, First-Time Setup, and Field-Replaceable Unit Guide
Use and Care Guide
Downloads: This chapterpdf (PDF - 439.0KB) The complete bookPDF (PDF - 27.64MB) | Feedback

Table of Contents

Use & Care Guide

Maintaining the Tabletop

Cleaning the Displays

Cleaning the Camera Lens

Cleaning the Display Screens

Use & Care Guide

Revised: July 17, 2014, OL-27038-01

Maintaining the Tabletop


Caution Waxing or rubbing the surface with any type of abrasive is not recommended.

  • For general daily care - use a dampened cloth with clean water.
  • To remove dirt - use a mild soap and water solution. Wipe off with clean water afterward to remove the soap.
  • To remove ink marks - rub the stained area with a pencil eraser.
  • To polish the tabletop - use lemon oil.

Note Lemon oil is not recommended for daily use.


Cleaning the Displays

Wipe the panel surface gently using only a cleaning cloth or a soft, lint-free cloth. If the surface is particularly dirty, wipe with a soft, lint-free cloth which has been soaked in pure water or water to which a small amount of neutral detergent has been added, and then wipe it evenly with a dry cloth of the same type until the surface is dry.

Cleaning the Camera Lens


Caution Do not touch the camera after installation is completed. If you need to clean the camera lens, use a dry microfiber cloth. After cleaning, you will need to realign the camera.

Cleaning the Display Screens

Use a clean, soft cloth with warm water and mild soap to remove any marks on your Cisco TelePresence white speaker screens.


Caution Using anything other than a soft cloth, warm water and mild soap may permanently damage the display screen.