Installation and Administration Guide for the Cisco TelePresence Exchange System Release 1.1
Installation Worksheets
Downloads: This chapterpdf (PDF - 64.0KB) The complete bookPDF (PDF - 3.66MB) | Feedback

Installation Worksheets

Table Of Contents

Installation Worksheets


Installation Worksheets


Complete these worksheets before you install the software on the Cisco TelePresence Exchange System database, administration, and call engine servers. For details and requirements, see the "Gathering Required Information Before Installation" section.

Table A-1 Worksheet for Cisco TelePresence Exchange System Servers 

Node
Hostname
IP Address
Subnet Mask
Username
Password

Database—shared virtual1

     

Database—primary

     

Database—secondary

     

Engine 1

     

Engine 2

     

Admin 1

     

Admin 2

     

Default gateway for the data VLAN

 

Administrator username and password for accessing the CLI of any node in the cluster2

   

Security password to authenticate data requests between the database server and the other servers3

 

Database—primary IMM4 (optional)

       

Database—secondary IMM (optional)

       

Engine 1—IMM (optional)

       

Engine 2—IMM (optional)

       

Admin 1—IMM (optional)

       

Admin 2—IMM (optional)

       

Default gateway for the IMM VLAN

 

1 The virtual hostname and virtual IP (VIP) address are shared by both the primary and secondary database servers.

2 You must use the same administrator username and password on all Cisco TelePresence Exchange System servers.

3 The security password must be identical for all nodes in the server cluster. After you set the security password on a server, you cannot change it without reinstalling the server.

4 IMM = integrated management module. Use and setup of the IMM is optional, but the IMM enables remote control of the server.


Table A-2 Worksheet for Other Solution Components 

Component
Information
Value

SIP load balancer (ACE1 )

VIP2 address

 

Port3

 

DNS4 (optional)

IP address of primary DNS server

 

IP address of secondary DNS server (optional)

 

Domain name5

 

NTP6

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

Server IP address, server hostname, or pool name

 

1 ACE = Cisco Application Control Engine.

2 VIP = virtual IP address.

3 Cisco recommends that you use the default port 5060.

4 DNS = Domain Name System.

5 Example domain names: cisco.com, example.net.

6 NTP = network time protocol. Only one NTP entry is required, but Cisco recommends that you have at least three clocking sources.


Table A-3 Worksheet for Generating LSCs1 for the Cisco TelePresence Exchange System Servers 

Node
Organization
Unit
Location
State
Country

Database—primary

         

Database—secondary

         

Engine 1

         

Engine 2

         

Admin 1

         

Admin 2

         

1 LSC = locally significant certificate