Cisco TelePresence System 500-37 Assembly, Use & Care, and Field-Replaceable Unit Guide
Preface
Downloads: This chapterpdf (PDF - 155.0KB) The complete bookPDF (PDF - 25.35MB) | Feedback

Preface

Table Of Contents

Preface

Introduction

Chapter Organization

Conventions

Obtaining Documentation and Submitting a Service Request

Related Documentation


Preface


Revised: June 10, 2011, OL-14522-01

Introduction

The Cisco TelePresence System 500-37 Assembly Guide outlines the steps and best practices for assembling and installing the Cisco TelePresence System 500-37 (CTS-500-37). It also includes first-time setup procedures, care instructions for the display screen, and procedures to replace field-replaceable units (FRUs).

This guide is intended primarily for installers of the CTS-500-37. Site planners, network administrators, and facility maintenance personnel may also find this document useful.

This preface includes the following sections:

Chapter Organization

Conventions

Obtaining Documentation and Submitting a Service Request

Related Documentation

Chapter Organization

This section provides an overview of the organization of this book.

Chapter 1, "Cisco TelePresence System 500-37 Room Recommendations" (this chapter)

Provides chapter organization and content of this document.

Provides CTS-500-37 placement guidelines for installation locations with and without windows.

Provides you with power and HVAC requirements and recommendations.

Lists the tools that are required to install the CTS-500-37.

Chapter 2, "Assembling a Pedestal Stand-Mounted CTS-500-37"

Provides the steps to assemble the CTS-500-37 in a pedestal stand-mounted configuration.


Note A pedestal stand mounts on the floor.


Chapter 3, "Assembling a Wall-Mounted CTS-500-37"

Provides the steps to assemble the CTS-500-37 in a wall-mounted configuration.

Chapter 4, "Assembling a Table Stand-Mounted CTS-500-37"

Provides the steps to assemble the CTS-500-37 in a table stand-mounted configuration.

Chapter 5, "First-Time Setup"

Describes the configuration you perform to set up your CTS-500-37 for the first time.

Chapter 6, "Use and Care Guide"

Describes the cleaning procedure for the display screen.

Chapter A, "Field-Replaceable Unit Guide"

Describes removal and replacement procedures for various hardware elements of the CTS-500-37.

Appendix B, "Cisco TelePresence System 500-37 Height, Width, and Weight Specifications"

Describes the height and weight of the system and various components of the system.

Appendix C, "Region- and Country-Specific Equipment"

Describes the power cords that are specific to a region or country.

Conventions

This document uses the following conventions to convey information and alert the user to conditions requiring special awareness.


Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, you must be aware of the hazards involved with electrical circuitry and familiar with standard practices for preventing accidents.



Caution Means reader be careful. In this situation, you might do something that could result in equipment damage or loss of data.


Note Means reader take note. Notes contain helpful suggestions or references to material not covered in the publication.



Tip Means the information contains useful tips.


Obtaining Documentation and Submitting a Service Request

For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:

http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html

Subscribe to the What's New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports RSS Version 2.0.

Related Documentation

The Cisco TelePresence system documentation set includes a variety of online and printed guides designed to aid the assemblers, installers, system administrators, and users in the setup, configuration, administration, and use of Cisco TelePresence.

To obtain the latest version and release of these documents, navigate to the Cisco TelePresence documentation site at the URL following the document title.

Cisco Unified Communications Manager Installation Guide for Cisco TelePresence System

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_installation_guides_list.html

Release Notes for Cisco TelePresence Administration Software

http://www.cisco.com/en/US/products/ps8332/prod_release_notes_list.html

Cisco TelePresence System Meeting Quick Reference

http://www.cisco.com/en/US/products/ps8332/products_user_guide_list.html

Cisco TelePresence System Phone User Guide

http://www.cisco.com/en/US/products/ps8332/products_user_guide_list.html

Cisco TelePresence System Administrator's Guide

http://www.cisco.com/en/US/products/ps8332/prod_maintenance_guides_list.html

Cisco TelePresence System Software End User License Agreement

http://www.cisco.com/en/US/products/ps8332/prod_maintenance_guides_list.html

Cisco TelePresence Manager Release Notes

http://www.cisco.com/en/US/products/ps7074/prod_release_notes_list.html

Cisco TelePresence Manager Administration & Installation Guide

http://www.cisco.com/en/US/products/ps7074/prod_maintenance_guides_list.html

Cisco TelePresence Manager Software End User License Agreement

http://www.cisco.com/en/US/products/ps7074/prod_maintenance_guides_list.html