Cisco EnergyWise Configuration Guide, EnergyWise Phase 2
EnergyWise and Catalyst 6500 Switches
Downloads: This chapterpdf (PDF - 72.0KB) The complete bookPDF (PDF - 2.52MB) | Feedback

Cisco EnergyWise and Catalyst 6500 Switches

Table Of Contents

Cisco EnergyWise and Catalyst 6500 Switches


Cisco EnergyWise and Catalyst 6500 Switches


For Catalyst 6500 switches running EnergyWise Phase 2 and later:

For high availability

To perform an ISSU downgrade from a Cisco IOS release supporting EnergyWise Phase 2 to an earlier software release that does not support EnergyWise, disable EnergyWise on the switch first.

To perform an ISSU downgrade from a Cisco IOS release supporting EnergyWise Phase 2 to an earlier release that does not support EnergyWise, remove the snmp-server enable traps energywise global configuration command from the switch configuration.

For stateful switchover (SSO) mode

On a redundant chassis operating in SSO mode, the energywise neighbor hostname udp-port-number global configuration command does not work. Use the energywise neighbor ip-address udp-port-number global configuration command to specify the IP address of the host.

For more information, see the "CLI Compatibility Issues" section in the "Managing Single Entities" chapter.