This appendix lists the supported management information base (MIBs) for this release on the Catalyst 3750 switch. It contains these sections:
•Using FTP to Access the MIB Files
Note The BRIDGE-MIB supports the context of a single VLAN. By default, SNMP messages using the configured community string always provide information for VLAN 1. To obtain the BRIDGE-MIB information for other VLANs, for example VLAN x, use this community string in the SNMP message: configured community string @x.
•CISCO-FLASH-MIB (Flash memory on all switches is modeled as removable flash memory.)
•CISCO-HSRP-EXT-MIB (partial support)
•CISCO-IETF-IP-MIB (advanced IP services image only)
•CISCO-IETF-IP-FORWARDING-MIB (advanced IP services image only)
•CISCO-IMAGE-MIB (Only stack master image details are shown.)
•CISCO-MEMORY-POOL-MIB (Only stack master image details are shown.)
•CISCO-PORT-QOS-MIB (only the packet counters are supported; the octet counters are not supported)
•CISCO-PROCESS-MIB (Only stack master details are shown.)
•CISCO-STACK-MIB (Partial support: for some objects, only stack master information is supported. ENTITY MIB is a better alternative.)
•IF-MIB (In and out counters for VLANs are not supported.)
•OLD-CISCO-CHASSIS-MIB (Partial support; some objects reflect only the stack master.)
•OLD-CISCO-FLASH-MIB (Supports only the stack master. Use CISCO-FLASH_MIB.)
•RFC1213-MIB (Functionality is as per the agent capabilities specified in the CISCO-RFC1213-CAPABILITY.my.)
Note You can also use this URL for a list of supported MIBs for the Catalyst 3750 switch:
You can access other information about MIBs and Cisco products on the Cisco web site:
Using FTP to Access the MIB Files
You can get each MIB file by using this procedure:
Step 1 Make sure that your FTP client is in passive mode.
Note Some FTP clients do not support passive mode.
Step 2 Use FTP to access the server ftp.cisco.com.
Step 3 Log in with the username anonymous.
Step 4 Enter your e-mail username when prompted for the password.
Step 5 At the
ftp> prompt, change directories to /pub/mibs/v1 and /pub/mibs/v2.
Step 6 Use the get MIB_filename command to obtain a copy of the MIB file.